buildroot

History

Giulio Benetti e0ee4f4152 configs/amarula_vyasa_rk3288: bump to Linux kernel 5.14.13 and u-boot 2021.10 This bumps to linux 5.14.13, linux-headers 5.14 and u-boot version 2021.10 and drop local uboot patch where CONFIG_SYS_BOOTM_LEN was set to 16MB because on u-boot 2021.10 it's now set to 64MB as default to make room for Linux images. Signed-off-by: Giulio Benetti <giulio.benetti@benettiengineering.com> Signed-off-by: Thomas Petazzoni <thomas.petazzoni@bootlin.com>		2021-10-24 16:05:14 +02:00
..
extlinux.conf	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00
genimage.cfg	board: amarula: vyasa: Give raw space for falcon mode	2018-05-27 22:05:35 +02:00
linux_gmac.fragment	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00
post-build.sh	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00
readme.txt	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00

readme.txt

Vyasa RK3288
============

Vyasa is RK3288 based Single board computer with fully supported opensource software.

https://openedev.amarulasolutions.com/display/ODWIKI/Vyasa+RK3288

How to build it
===============

  $ make amarula_vyasa_rk3288_defconfig

Then you can edit the build options using

  $ make menuconfig

Compile all and build rootfs image:

  $ make

Prepare your SDCard
===================

Buildroot generates a ready-to-use SD card image that you can flash directly to
the card. The image will be in output/images/sdcard.img.
You can write this image directly to an SD card device (i.e. /dev/xxx):

  $ sudo dd if=output/images/sdcard.img of=/dev/xxx
  $ sudo sync

Finally, you can insert the SD card to the Vyasa RK3288 board, close J4 and boot it.