micropython/drivers/nrf24l01/nrf24l01test.py

151 lines
4.7 KiB
Python

"""Test for nrf24l01 module. Portable between MicroPython targets."""
import usys
import ustruct as struct
import utime
from machine import Pin, SPI
from nrf24l01 import NRF24L01
from micropython import const
# Slave pause between receiving data and checking for further packets.
_RX_POLL_DELAY = const(15)
# Slave pauses an additional _SLAVE_SEND_DELAY ms after receiving data and before
# transmitting to allow the (remote) master time to get into receive mode. The
# master may be a slow device. Value tested with Pyboard, ESP32 and ESP8266.
_SLAVE_SEND_DELAY = const(10)
if usys.platform == "pyboard":
cfg = {"spi": 2, "miso": "Y7", "mosi": "Y8", "sck": "Y6", "csn": "Y5", "ce": "Y4"}
elif usys.platform == "esp8266": # Hardware SPI
cfg = {"spi": 1, "miso": 12, "mosi": 13, "sck": 14, "csn": 4, "ce": 5}
elif usys.platform == "esp32": # Software SPI
cfg = {"spi": -1, "miso": 32, "mosi": 33, "sck": 25, "csn": 26, "ce": 27}
else:
raise ValueError("Unsupported platform {}".format(usys.platform))
# Addresses are in little-endian format. They correspond to big-endian
# 0xf0f0f0f0e1, 0xf0f0f0f0d2
pipes = (b"\xe1\xf0\xf0\xf0\xf0", b"\xd2\xf0\xf0\xf0\xf0")
def master():
csn = Pin(cfg["csn"], mode=Pin.OUT, value=1)
ce = Pin(cfg["ce"], mode=Pin.OUT, value=0)
if cfg["spi"] == -1:
spi = SPI(-1, sck=Pin(cfg["sck"]), mosi=Pin(cfg["mosi"]), miso=Pin(cfg["miso"]))
nrf = NRF24L01(spi, csn, ce, payload_size=8)
else:
nrf = NRF24L01(SPI(cfg["spi"]), csn, ce, payload_size=8)
nrf.open_tx_pipe(pipes[0])
nrf.open_rx_pipe(1, pipes[1])
nrf.start_listening()
num_needed = 16
num_successes = 0
num_failures = 0
led_state = 0
print("NRF24L01 master mode, sending %d packets..." % num_needed)
while num_successes < num_needed and num_failures < num_needed:
# stop listening and send packet
nrf.stop_listening()
millis = utime.ticks_ms()
led_state = max(1, (led_state << 1) & 0x0F)
print("sending:", millis, led_state)
try:
nrf.send(struct.pack("ii", millis, led_state))
except OSError:
pass
# start listening again
nrf.start_listening()
# wait for response, with 250ms timeout
start_time = utime.ticks_ms()
timeout = False
while not nrf.any() and not timeout:
if utime.ticks_diff(utime.ticks_ms(), start_time) > 250:
timeout = True
if timeout:
print("failed, response timed out")
num_failures += 1
else:
# recv packet
(got_millis,) = struct.unpack("i", nrf.recv())
# print response and round-trip delay
print(
"got response:",
got_millis,
"(delay",
utime.ticks_diff(utime.ticks_ms(), got_millis),
"ms)",
)
num_successes += 1
# delay then loop
utime.sleep_ms(250)
print("master finished sending; successes=%d, failures=%d" % (num_successes, num_failures))
def slave():
csn = Pin(cfg["csn"], mode=Pin.OUT, value=1)
ce = Pin(cfg["ce"], mode=Pin.OUT, value=0)
if cfg["spi"] == -1:
spi = SPI(-1, sck=Pin(cfg["sck"]), mosi=Pin(cfg["mosi"]), miso=Pin(cfg["miso"]))
nrf = NRF24L01(spi, csn, ce, payload_size=8)
else:
nrf = NRF24L01(SPI(cfg["spi"]), csn, ce, payload_size=8)
nrf.open_tx_pipe(pipes[1])
nrf.open_rx_pipe(1, pipes[0])
nrf.start_listening()
print("NRF24L01 slave mode, waiting for packets... (ctrl-C to stop)")
while True:
if nrf.any():
while nrf.any():
buf = nrf.recv()
millis, led_state = struct.unpack("ii", buf)
print("received:", millis, led_state)
for led in leds:
if led_state & 1:
led.on()
else:
led.off()
led_state >>= 1
utime.sleep_ms(_RX_POLL_DELAY)
# Give master time to get into receive mode.
utime.sleep_ms(_SLAVE_SEND_DELAY)
nrf.stop_listening()
try:
nrf.send(struct.pack("i", millis))
except OSError:
pass
print("sent response")
nrf.start_listening()
try:
import pyb
leds = [pyb.LED(i + 1) for i in range(4)]
except:
leds = []
print("NRF24L01 test module loaded")
print("NRF24L01 pinout for test:")
print(" CE on", cfg["ce"])
print(" CSN on", cfg["csn"])
print(" SCK on", cfg["sck"])
print(" MISO on", cfg["miso"])
print(" MOSI on", cfg["mosi"])
print("run nrf24l01test.slave() on slave, then nrf24l01test.master() on master")