1
0
Fork 0
alistair23-linux/Documentation/devicetree/bindings/net/qcom,ethqos.txt

65 lines
1.5 KiB
Plaintext
Raw Normal View History

Qualcomm Ethernet ETHQOS device
This documents dwmmac based ethernet device which supports Gigabit
ethernet for version v2.3.0 onwards.
This device has following properties:
Required properties:
- compatible: Should be qcom,qcs404-ethqos"
- reg: Address and length of the register set for the device
- reg-names: Should contain register names "stmmaceth", "rgmii"
- clocks: Should contain phandle to clocks
- clock-names: Should contain clock names "stmmaceth", "pclk",
"ptp_ref", "rgmii"
- interrupts: Should contain phandle to interrupts
- interrupt-names: Should contain interrupt names "macirq", "eth_lpi"
Rest of the properties are defined in stmmac.txt file in same directory
Example:
ethernet: ethernet@7a80000 {
compatible = "qcom,qcs404-ethqos";
reg = <0x07a80000 0x10000>,
<0x07a96000 0x100>;
reg-names = "stmmaceth", "rgmii";
clock-names = "stmmaceth", "pclk", "ptp_ref", "rgmii";
clocks = <&gcc GCC_ETH_AXI_CLK>,
<&gcc GCC_ETH_SLAVE_AHB_CLK>,
<&gcc GCC_ETH_PTP_CLK>,
<&gcc GCC_ETH_RGMII_CLK>;
interrupts = <GIC_SPI 56 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "macirq", "eth_lpi";
snps,reset-gpio = <&tlmm 60 GPIO_ACTIVE_LOW>;
snps,reset-active-low;
snps,txpbl = <8>;
snps,rxpbl = <2>;
snps,aal;
snps,tso;
phy-handle = <&phy1>;
phy-mode = "rgmii";
mdio {
#address-cells = <0x1>;
#size-cells = <0x0>;
compatible = "snps,dwmac-mdio";
phy1: phy@4 {
device_type = "ethernet-phy";
reg = <0x4>;
};
};
};