From 18ec92b1ce2975f8d27af868084c70835b86ace4 Mon Sep 17 00:00:00 2001 From: Serge Semin Date: Fri, 31 Jul 2020 23:08:23 +0300 Subject: [PATCH] dmaengine: dw: Activate FIFO-mode for memory peripherals only [ Upstream commit 6d9459d04081c796fc67c2bb771f4e4ebb5744c4 ] CFGx.FIFO_MODE field controls a DMA-controller "FIFO readiness" criterion. In other words it determines when to start pushing data out of a DW DMAC channel FIFO to a destination peripheral or from a source peripheral to the DW DMAC channel FIFO. Currently FIFO-mode is set to one for all DW DMAC channels. It means they are tuned to flush data out of FIFO (to a memory peripheral or by accepting the burst transaction requests) when FIFO is at least half-full (except at the end of the block transfer, when FIFO-flush mode is activated) and are configured to get data to the FIFO when it's at least half-empty. Such configuration is a good choice when there is no slave device involved in the DMA transfers. In that case the number of bursts per block is less than when CFGx.FIFO_MODE = 0 and, hence, the bus utilization will improve. But the latency of DMA transfers may increase when CFGx.FIFO_MODE = 1, since DW DMAC will wait for the channel FIFO contents to be either half-full or half-empty depending on having the destination or the source transfers. Such latencies might be dangerous in case if the DMA transfers are expected to be performed from/to a slave device. Since normally peripheral devices keep data in internal FIFOs, any latency at some critical moment may cause one being overflown and consequently losing data. This especially concerns a case when either a peripheral device is relatively fast or the DW DMAC engine is relatively slow with respect to the incoming data pace. In order to solve problems, which might be caused by the latencies described above, let's enable the FIFO half-full/half-empty "FIFO readiness" criterion only for DMA transfers with no slave device involved. Thanks to the commit 99ba8b9b0d97 ("dmaengine: dw: Initialize channel before each transfer") we can freely do that in the generic dw_dma_initialize_chan() method. Signed-off-by: Serge Semin Reviewed-by: Andy Shevchenko Link: https://lore.kernel.org/r/20200731200826.9292-3-Sergey.Semin@baikalelectronics.ru Signed-off-by: Vinod Koul Signed-off-by: Sasha Levin --- drivers/dma/dw/dw.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/dma/dw/dw.c b/drivers/dma/dw/dw.c index 7a085b3c1854..d9810980920a 100644 --- a/drivers/dma/dw/dw.c +++ b/drivers/dma/dw/dw.c @@ -14,7 +14,7 @@ static void dw_dma_initialize_chan(struct dw_dma_chan *dwc) { struct dw_dma *dw = to_dw_dma(dwc->chan.device); - u32 cfghi = DWC_CFGH_FIFO_MODE; + u32 cfghi = is_slave_direction(dwc->direction) ? 0 : DWC_CFGH_FIFO_MODE; u32 cfglo = DWC_CFGL_CH_PRIOR(dwc->priority); bool hs_polarity = dwc->dws.hs_polarity;