e1000: remove dead e1000_init_eeprom_params calls

The device probe method e1000_probe calls e1000_init_eeprom_params
itself so there's no reason to call it again from e1000_do_write_eeprom
or e1000_do_read_eeprom.

The sentence above assumes that e1000_init_eeprom_params is effective.
e1000_init_eeprom_params depends mostly on hw->mac_type and e1000_probe
bails out early if it can't set mac_type (see e1000_init_hw_struct, then
e1000_set_mac_type), qed.

Btw, if effective, the removed paths would had been deadlock prone when
e1000_eeprom_spi was set:
-> e1000_write_eeprom (takes e1000_eeprom_lock)
   -> e1000_do_write_eeprom
      -> e1000_init_eeprom_params
         -> e1000_read_eeprom (takes e1000_eeprom_lock)

(same narrative with e1000_read_eeprom -> e1000_do_read_eeprom etc.)

As a final note, the candidate deadlock above can't happen in e1000_probe
due to the way eeprom->word_size is set / tested.

Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/e1000/e1000_hw.c

@@ -3900,10 +3900,6 @@ static s32 e1000_do_read_eeprom(struct e1000_hw *hw, u16 offset, u16 words,
 		return E1000_SUCCESS;
 	}
 
-	/* If eeprom is not yet detected, do so now */
-	if (eeprom->word_size == 0)
-		e1000_init_eeprom_params(hw);
-
 	/* A check for invalid values:  offset too large, too many words, and
 	 * not enough words.
 	 */
@@ -4074,10 +4070,6 @@ static s32 e1000_do_write_eeprom(struct e1000_hw *hw, u16 offset, u16 words,
 		return E1000_SUCCESS;
 	}
 
-	/* If eeprom is not yet detected, do so now */
-	if (eeprom->word_size == 0)
-		e1000_init_eeprom_params(hw);
-
 	/* A check for invalid values:  offset too large, too many words, and
 	 * not enough words.
 	 */