mmc: core: Invoke mmc_pwrseq_post_power_on() prior MMC_POWER_ON state
Host drivers have different ways to sends their "init stream" to the card. Some need to do it as part of a request, some do it from the ->set_ios() callback in the MMC_POWER_ON state and some don't send an "init stream" at all. To be able to use the reset GPIOs from the simple MMC power sequence provider, the card need to be powered and the "init stream" must not have been sent. To cope with these requirements, invoke mmc_pwrseq_post_power_on() prior we change the state to MMC_POWER_ON in mmc_power_up(). Host drivers shall perform power up operations in the MMC_POWER_UP state. Unfortunate three hosts (au1xmmc, cb710-mmc and toshsd) don't conform to this expectation. Instead those ignore the MMC_POWER_UP state and delays their power up operations to the MMC_POWER_ON state. Those hosts needs to change their behavior to enable proper support for the simple MMC power sequence provider. Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org> Reviewed-by: Javier Martinez Canillas <javier.martinez@collabora.co.uk> Tested-by: Javier Martinez Canillas <javier.martinez@collabora.co.uk>
This commit is contained in:
parent
c13045b1e9
commit
4febb7e20a
|
@ -1637,6 +1637,8 @@ void mmc_power_up(struct mmc_host *host, u32 ocr)
|
|||
*/
|
||||
mmc_delay(10);
|
||||
|
||||
mmc_pwrseq_post_power_on(host);
|
||||
|
||||
host->ios.clock = host->f_init;
|
||||
|
||||
host->ios.power_mode = MMC_POWER_ON;
|
||||
|
@ -1648,8 +1650,6 @@ void mmc_power_up(struct mmc_host *host, u32 ocr)
|
|||
*/
|
||||
mmc_delay(10);
|
||||
|
||||
mmc_pwrseq_post_power_on(host);
|
||||
|
||||
mmc_host_clk_release(host);
|
||||
}
|
||||
|
||||
|
|
Loading…
Reference in a new issue