1
0
Fork 0

net: phy: dp83867: Add SGMII mode type switching

This patch adds ability to switch beetween two PHY SGMII modes.
Some hardware, for example, FPGA IP designs may use 6-wire mode
which enables differential SGMII clock to MAC.

Signed-off-by: Vitaly Gaiduk <vitaly.gaiduk@cloudbear.ru>
Signed-off-by: David S. Miller <davem@davemloft.net>
alistair/sunxi64-5.4-dsi
Vitaly Gaiduk 2019-09-09 20:19:24 +03:00 committed by David S. Miller
parent a2111c460c
commit 507ddd5c0d
1 changed files with 19 additions and 0 deletions

View File

@ -37,6 +37,7 @@
#define DP83867_STRAP_STS2 0x006f
#define DP83867_RGMIIDCTL 0x0086
#define DP83867_IO_MUX_CFG 0x0170
#define DP83867_SGMIICTL 0x00D3
#define DP83867_10M_SGMII_CFG 0x016F
#define DP83867_10M_SGMII_RATE_ADAPT_MASK BIT(7)
@ -61,6 +62,9 @@
#define DP83867_RGMII_TX_CLK_DELAY_EN BIT(1)
#define DP83867_RGMII_RX_CLK_DELAY_EN BIT(0)
/* SGMIICTL bits */
#define DP83867_SGMII_TYPE BIT(14)
/* STRAP_STS1 bits */
#define DP83867_STRAP_STS1_RESERVED BIT(11)
@ -109,6 +113,7 @@ struct dp83867_private {
bool rxctrl_strap_quirk;
bool set_clk_output;
u32 clk_output_sel;
bool sgmii_ref_clk_en;
};
static int dp83867_ack_interrupt(struct phy_device *phydev)
@ -197,6 +202,9 @@ static int dp83867_of_init(struct phy_device *phydev)
dp83867->rxctrl_strap_quirk = of_property_read_bool(of_node,
"ti,dp83867-rxctrl-strap-quirk");
dp83867->sgmii_ref_clk_en = of_property_read_bool(of_node,
"ti,sgmii-ref-clock-output-enable");
/* Existing behavior was to use default pin strapping delay in rgmii
* mode, but rgmii should have meant no delay. Warn existing users.
*/
@ -389,6 +397,17 @@ static int dp83867_config_init(struct phy_device *phydev)
if (ret)
return ret;
val = phy_read_mmd(phydev, DP83867_DEVADDR, DP83867_SGMIICTL);
/* SGMII type is set to 4-wire mode by default.
* If we place appropriate property in dts (see above)
* switch on 6-wire mode.
*/
if (dp83867->sgmii_ref_clk_en)
val |= DP83867_SGMII_TYPE;
else
val &= ~DP83867_SGMII_TYPE;
phy_write_mmd(phydev, DP83867_DEVADDR, DP83867_SGMIICTL, val);
}
/* Enable Interrupt output INT_OE in CFG3 register */