pinctrl/lantiq: Fix GPIO Setup of GPIO Port3
Some special handling of GPIO Port 3 is needed because of some hardware thingofabob. Signed-off-by: John Crispin <blogic@openwrt.org> Signed-off-by: Martin Schiller <mschiller@tdt.de> Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This commit is contained in:
parent
be14811c03
commit
57b588c950
|
@ -1563,6 +1563,10 @@ static int xway_gpio_dir_out(struct gpio_chip *chip, unsigned int pin, int val)
|
||||||
{
|
{
|
||||||
struct ltq_pinmux_info *info = dev_get_drvdata(chip->dev);
|
struct ltq_pinmux_info *info = dev_get_drvdata(chip->dev);
|
||||||
|
|
||||||
|
if (PORT(pin) == PORT3)
|
||||||
|
gpio_setbit(info->membase[0], GPIO3_OD, PORT_PIN(pin));
|
||||||
|
else
|
||||||
|
gpio_setbit(info->membase[0], GPIO_OD(pin), PORT_PIN(pin));
|
||||||
gpio_setbit(info->membase[0], GPIO_DIR(pin), PORT_PIN(pin));
|
gpio_setbit(info->membase[0], GPIO_DIR(pin), PORT_PIN(pin));
|
||||||
xway_gpio_set(chip, pin, val);
|
xway_gpio_set(chip, pin, val);
|
||||||
|
|
||||||
|
|
Loading…
Reference in a new issue