diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
index 83bc848aa34d..ab1af2b06993 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -100,6 +100,7 @@
 /* NOTE: the minimum valid tuning start tap for mx6sl is 1 */
 #define ESDHC_TUNING_START_TAP_DEFAULT	0x1
 #define ESDHC_TUNING_START_TAP_MASK	0x7f
+#define ESDHC_TUNING_CMD_CRC_CHECK_DISABLE	(1 << 7)
 #define ESDHC_TUNING_STEP_MASK		0x00070000
 #define ESDHC_TUNING_STEP_SHIFT		16
 
@@ -1336,6 +1337,18 @@ static void sdhci_esdhc_imx_hwinit(struct sdhci_host *host)
 				tmp |= imx_data->boarddata.tuning_step
 					<< ESDHC_TUNING_STEP_SHIFT;
 			}
+
+			/* Disable the CMD CRC check for tuning, if not, need to
+			 * add some delay after every tuning command, because
+			 * hardware standard tuning logic will directly go to next
+			 * step once it detect the CMD CRC error, will not wait for
+			 * the card side to finally send out the tuning data, trigger
+			 * the buffer read ready interrupt immediately. If usdhc send
+			 * the next tuning command some eMMC card will stuck, can't
+			 * response, block the tuning procedure or the first command
+			 * after the whole tuning procedure always can't get any response.
+			 */
+			 tmp |= ESDHC_TUNING_CMD_CRC_CHECK_DISABLE;
 			writel(tmp, host->ioaddr + ESDHC_TUNING_CTRL);
 		} else if (imx_data->socdata->flags & ESDHC_FLAG_MAN_TUNING) {
 			/*
@@ -1677,8 +1690,6 @@ static int sdhci_esdhc_imx_probe(struct platform_device *pdev)
 	if (err)
 		goto disable_ahb_clk;
 
-	host->tuning_delay = 1;
-
 	sdhci_esdhc_imx_hwinit(host);
 
 	if ((host->mmc->pm_caps & MMC_PM_KEEP_POWER) &&