Merge branch 'topic/bam' into for-linus

Conflicts:
	drivers/dma/Makefile

Signed-off-by: Vinod Koul <vinod.koul@intel.com>

Documentation/devicetree/bindings/dma/qcom_bam_dma.txt

@@ -0,0 +1,41 @@
+QCOM BAM DMA controller
+
+Required properties:
+- compatible: must contain "qcom,bam-v1.4.0" for MSM8974
+- reg: Address range for DMA registers
+- interrupts: Should contain the one interrupt shared by all channels
+- #dma-cells: must be <1>, the cell in the dmas property of the client device
+  represents the channel number
+- clocks: required clock
+- clock-names: must contain "bam_clk" entry
+- qcom,ee : indicates the active Execution Environment identifier (0-7) used in
+  the secure world.
+
+Example:
+
+	uart-bam: dma@f9984000 = {
+		compatible = "qcom,bam-v1.4.0";
+		reg = <0xf9984000 0x15000>;
+		interrupts = <0 94 0>;
+		clocks = <&gcc GCC_BAM_DMA_AHB_CLK>;
+		clock-names = "bam_clk";
+		#dma-cells = <1>;
+		qcom,ee = <0>;
+	};
+
+DMA clients must use the format described in the dma.txt file, using a two cell
+specifier for each channel.
+
+Example:
+	serial@f991e000 {
+		compatible = "qcom,msm-uart";
+		reg = <0xf991e000 0x1000>
+			<0xf9944000 0x19000>;
+		interrupts = <0 108 0>;
+		clocks = <&gcc GCC_BLSP1_UART2_APPS_CLK>,
+			<&gcc GCC_BLSP1_AHB_CLK>;
+		clock-names = "core", "iface";
+
+		dmas = <&uart-bam 0>, <&uart-bam 1>;
+		dma-names = "rx", "tx";
+	};

drivers/dma/Kconfig

@@ -410,4 +410,13 @@ config DMATEST
 config DMA_ENGINE_RAID
 	bool
 
+config QCOM_BAM_DMA
+	tristate "QCOM BAM DMA support"
+	depends on ARCH_QCOM || (COMPILE_TEST && OF && ARM)
+	select DMA_ENGINE
+	select DMA_VIRTUAL_CHANNELS
+	---help---
+	  Enable support for the QCOM BAM DMA controller.  This controller
+	  provides DMA capabilities for a variety of on-chip devices.
+
 endif

drivers/dma/Makefile

@@ -45,3 +45,4 @@ obj-$(CONFIG_TI_CPPI41) += cppi41.o
 obj-$(CONFIG_K3_DMA) += k3dma.o
 obj-$(CONFIG_MOXART_DMA) += moxart-dma.o
 obj-$(CONFIG_FSL_EDMA) += fsl-edma.o
+obj-$(CONFIG_QCOM_BAM_DMA) += qcom_bam_dma.o