From bd859c6598dd2b73c517b3a36ecc5dd387eb1eb2 Mon Sep 17 00:00:00 2001 From: Jaegeuk Kim Date: Wed, 5 Feb 2014 11:16:39 +0900 Subject: [PATCH] f2fs: fix to truncate dentry pages in the error case When a new directory is allocated, if an error is occurred, we should truncate preallocated dentry pages too. This bug was reported by Andrey Tsyvarev after a while as follows. mkdir()-> f2fs_add_link()-> init_inode_metadata()-> f2fs_init_acl()-> f2fs_get_acl()-> f2fs_getxattr()-> read_all_xattrs() fails. Also there was a BUG_ON triggered after the fault in mkdir()-> f2fs_add_link()-> init_inode_metadata()-> remove_inode_page() -> f2fs_bug_on(inode->i_blocks != 0 && inode->i_blocks != 1); But, previous patch wasn't perfect to resolve that bug, so the following bug report was also submitted. kernel BUG at fs/f2fs/inode.c:274! Call Trace: [] evict+0xa3/0x1a0 [] iput+0xf5/0x180 [] f2fs_mkdir+0xf3/0x150 [f2fs] [] vfs_mkdir+0xb7/0x160 [] SyS_mkdir+0x5f/0xc0 [] system_call_fastpath+0x16/0x1b Finally, this patch resolves all the issues like below. If an error is occurred after make_empty_dir(), 1. truncate_inode_pages() The make_bad_inode() prior to iput() will change i_mode to S_IFREG, which means that f2fs will not decrement fi->dirty_dents during f2fs_evict_inode. But, by calling it here, we can do that. 2. truncate_blocks() Preallocated dentry pages are trucated here to sync i_blocks. 3. remove_dirty_dir_inode() Remove this directory inode from the list. Reported-and-Tested-by: Andrey Tsyvarev Signed-off-by: Jaegeuk Kim --- fs/f2fs/dir.c | 4 ++++ 1 file changed, 4 insertions(+) diff --git a/fs/f2fs/dir.c b/fs/f2fs/dir.c index bfcb4ae241f8..5bbf94c31180 100644 --- a/fs/f2fs/dir.c +++ b/fs/f2fs/dir.c @@ -372,6 +372,10 @@ static struct page *init_inode_metadata(struct inode *inode, put_error: f2fs_put_page(page, 1); + /* once the failed inode becomes a bad inode, i_mode is S_IFREG */ + truncate_inode_pages(&inode->i_data, 0); + truncate_blocks(inode, 0); + remove_dirty_dir_inode(inode); error: remove_inode_page(inode); return ERR_PTR(err);