Add 3.3V and 12V supplies regulators information of x16 PCIe slot in
p2972-0000 platform which is owned by C5 controller and also enable C5
controller.
Signed-off-by: Vidya Sagar <vidyas@nvidia.com>
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Reviewed-by: Andrew Murray <andrew.murray@arm.com>
P2888 is the internal part number for the Jetson AGX Xavier module.
Clarify that using the DT model property.
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
The VCC supply property is not populated for the temperature sensor on
the P2888 board and so the following warning is observed on boot ...
lm90 0-004c: 0-004c supply vcc not found, using dummy regulator
On the P2888 board, the VCC supply for the temperature sensor is
connected to the 'vdd_1v8ls' rail. Add the 'vcc-supply' property for
the temperature sensor to prevent this warning message from occurring.
Fixes: 8b457812f5 ('arm64: tegra: Add temperature sensor on P2888')
Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
The Tegra Combined UART is the proper primary serial port on P2888,
so use it.
Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
Acked-by: Jon Hunter <jonathanh@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
The P2888 processor module contains a TI TMP451 temperature sensor with
two channels. These are used to measure the temperatures at different
locations on the module.
Signed-off-by: Thierry Reding <treding@nvidia.com>
The on-die RTC isn't hooked up to a backup battery, so it isn't useful
to track time across reboots, but as long as power remains enabled, it
keeps track of time accurately and can be used to wake the system from
sleep, for example.
Signed-off-by: Thierry Reding <treding@nvidia.com>
Add the 5V HDMI regulator and hook up the VDD_1V0 and VDD_1V8HS supplies
from the PMIC to the display block. Also enable the display hub which is
responsible for instantiating the display controllers. Finally, enable
the third SOR that drives the TMDS signals to the HDMI connector.
Signed-off-by: Thierry Reding <treding@nvidia.com>
The Tegra194 contains the same ethernet controller as the Tegra186.
Add the device tree node for it, and correspondingly the PHY node
on the board device tree.
Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
Now that we have a GPIO controller, enable the card detect GPIO for
the SD card slot.
Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
Add device tree files for the Tegra194 P2972-0000 development board.
The board consists of the P2888 compute module and the P2822 baseboard.
Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
Vidya Sagar