In order to ensure ordering and completion of inner-shareable maintenance
instructions (cache and TLB) on AArch64, we can use the -ish suffix to
the dmb and dsb instructions respectively.
This patch updates our low-level cache and tlb maintenance routines to
use the inner-shareable barrier variants where appropriate.
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
The current TCR register setting in arch/arm64/mm/proc.S assumes that
TCR_EL1.TG* fields are one bit wide and bit 31 is RES1 (reserved, set to
1). With the addition of 16K pages (currently unsupported in the
kernel), the TCR_EL1.TG* fields have been extended to two bits. This
patch updates the corresponding Linux definitions and drops the bit 31
setting in proc.S in favour of the new macros.
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Reported-by: Joe Sylve <joe.sylve@gmail.com>
ARMv8 supports a range of physical address bit sizes. The PARange bits
from ID_AA64MMFR0_EL1 register are read during boot-time and the
intermediate physical address size bits are written in the translation
control registers (TCR_EL1 and VTCR_EL2).
There is no change in the VA bits and levels of translation.
Signed-off-by: Radha Mohan Chintakuntla <rchintakuntla@cavium.com>
Reviewed-by: Will Deacon <Will.deacon@arm.com>
Acked-by: Marc Zyngier <marc.zyngier@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Currently we flush the entire dcache at boot within __cpu_setup, but
this is unnecessary as the booting protocol demands that the dcache is
invalid and off upon entering the kernel. The presence of the cache
flush only serves to hide bugs in bootloaders, and is not safe in the
presence of SMP.
In an SMP boot scenario the CPUs enter coherency outside of the kernel,
and the primary CPU enables its caches before bringing up secondary
CPUs. Therefore if any secondary CPU has an entry in its cache (in
violation of the boot protocol), the primary CPU might snoop it even if
the secondary CPU's cache is disabled. The boot-time cache flush only
serves to hide a firmware bug, and slows down a cpu boot unnecessarily.
This patch removes the unnecessary boot-time cache flush.
Signed-off-by: Mark Rutland <mark.rutland@arm.com>
Acked-by: Will Deacon <will.deacon@arm.com>
[catalin.marinas@arm.com: make __flush_dcache_all local only]
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Fix the function name of comment of cpu_do_switch_mm,
because cpu_do_switch_mm is the correct name.
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Power management software requires the kernel to save and restore
CPU registers while going through suspend and resume operations
triggered by kernel subsystems like CPU idle and suspend to RAM.
This patch implements code that provides save and restore mechanism
for the arm v8 implementation. Memory for the context is passed as
parameter to both cpu_do_suspend and cpu_do_resume functions, and allows
the callers to implement context allocation as they deem fit.
The registers that are saved and restored correspond to the registers set
actually required by the kernel to be up and running which represents a
subset of v8 ISA.
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Currently there is no dsb between the tlbi in __cpu_setup and the write
to SCTLR_EL1 which enables the MMU in __turn_mmu_on. This means that the
TLB invalidation is not guaranteed to have completed at the point
address translation is enabled, leading to a number of possible issues
including incorrect translations and TLB conflict faults.
This patch moves the tlbi in __cpu_setup above an existing dsb used to
synchronise I-cache invalidation, ensuring that the TLBs have been
invalidated at the point the MMU is enabled.
Signed-off-by: Mark Rutland <mark.rutland@arm.com>
Cc: Catalin Marinas <catalin.marinas@arm.com>
Cc: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
The endianness of memory accesses at EL2 and EL1 are configured by
SCTLR_EL2.EE and SCTLR_EL1.EE respectively. When the kernel is booted,
the state of SCTLR_EL{2,1}.EE is unknown, and thus the kernel must
ensure that they are set before performing any memory accesses.
This patch ensures that SCTLR_EL{2,1} are configured appropriately at
boot for kernels of either endianness.
Acked-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Matthew Leach <matthew.leach@arm.com>
[catalin.marinas@arm.com: fix SCTLR_EL1.E0E bit setting in head.S]
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
TCR.TBI0 can be used to cause hardware address translation to ignore the
top byte of userspace virtual addresses. Whilst not especially useful in
standard C programs, this can be used by JITs to `tag' pointers with
various pieces of metadata.
This patch enables this bit for AArch64 Linux, and adds a new file to
Documentation/arm64/ which describes some potential caveats when using
tagged virtual addresses.
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
During boot, we take the debug OS lock before interrupts are enabled.
This is required to prevent clearing of PSTATE.D on the interrupt entry
path, which could result in spurious debug exceptions before we've got
round to resetting things like the hardware breakpoints registers to a
sane state.
A problem with this approach is that taking the OS lock prevents an
external JTAG debugger from debugging the system, which is especially
irritating during boot, where JTAG debugging can be most useful.
This patch clears mdscr_el1 rather than taking the lock, clearing the
MDE and KDE bits and preventing self-hosted hardware debug exceptions
from occurring.
Tested-by: Mark Rutland <mark.rutland@arm.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Cc: stable@vger.kernel.org
If such bit exists on a given CPU, it must be set by the firmware or
boot-loader prior to starting the kernel (see
Documentation/arm64/booting.txt).
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
This patch adds AArch64 CPU specific functionality. It assumes that the
implementation is generic to AArch64 and does not require specific
identification. Different CPU implementations may require the setting of
various ACTLR_EL1 bits but such information is not currently available
and it should ideally be pushed to firmware.
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Acked-by: Nicolas Pitre <nico@linaro.org>
Acked-by: Olof Johansson <olof@lixom.net>
Acked-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Will Deacon