Merge the mvebu/drivers branch of the arm-soc tree which contains
just a single patch bfa1ce5f38 ("bus:
mvebu-mbus: add mv_mbus_dram_info_nooverlap()") that happens to be
a prerequisite of the new marvell/cesa crypto driver.
Since MD5 IV are now available in crypto/md5.h, use them.
Signed-off-by: LABBE Corentin <clabbe.montjoie@gmail.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Pull MIPS updates from Ralf Baechle:
"This is the main pull request for MIPS for Linux 4.1. Most
noteworthy:
- Add more Octeon-optimized crypto functions
- Octeon crypto preemption and locking fixes
- Little endian support for Octeon
- Use correct CSR to soft reset Octeons
- Support LEDs on the Octeon-based DSR-1000N
- Fix PCI interrupt mapping for the Octeon-based DSR-1000N
- Mark prom_free_prom_memory() as __init for a number of systems
- Support for Imagination's Pistachio SOC. This includes arch and
CLK bits. I'd like to merge pinctrl bits later
- Improve parallelism of csum_partial for certain pipelines
- Organize DTB files in subdirs like other architectures
- Implement read_sched_clock for all MIPS platforms other than
Octeon
- Massive series of 38 fixes and cleanups for the FPU emulator /
kernel
- Further FPU remulator work to support new features. This sits on a
separate branch which also has been pulled into the 4.1 KVM branch
- Clean up and fixes for the SEAD3 eval board; remove unused file
- Various updates for Netlogic platforms
- A number of small updates for Loongson 3 platforms
- Increase the memory limit for ATH79 platforms to 256MB
- A fair number of fixes and updates for BCM47xx platforms
- Finish the implementation of XPA support
- MIPS FDC support. No, not floppy controller but Fast Debug Channel :)
- Detect the R16000 used in SGI legacy platforms
- Fix Kconfig dependencies for the SSB bus support"
* 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus: (265 commits)
MIPS: Makefile: Fix MIPS ASE detection code
MIPS: asm: elf: Set O32 default FPU flags
MIPS: BCM47XX: Fix detecting Microsoft MN-700 & Asus WL500G
MIPS: Kconfig: Disable SMP/CPS for 64-bit
MIPS: Hibernate: flush TLB entries earlier
MIPS: smp-cps: cpu_set FPU mask if FPU present
MIPS: lose_fpu(): Disable FPU when MSA enabled
MIPS: ralink: add missing symbol for RALINK_ILL_ACC
MIPS: ralink: Fix bad config symbol in PCI makefile.
SSB: fix Kconfig dependencies
MIPS: Malta: Detect and fix bad memsize values
Revert "MIPS: Avoid pipeline stalls on some MIPS32R2 cores."
MIPS: Octeon: Delete override of cpu_has_mips_r2_exec_hazard.
MIPS: Fix cpu_has_mips_r2_exec_hazard.
MIPS: kernel: entry.S: Set correct ISA level for mips_ihb
MIPS: asm: spinlock: Fix addiu instruction for R10000_LLSC_WAR case
MIPS: r4kcache: Use correct base register for MIPS R6 cache flushes
MIPS: Kconfig: Fix typo for the r2-to-r6 emulator kernel parameter
MIPS: unaligned: Fix regular load/store instruction emulation for EVA
MIPS: unaligned: Surround load/store macros in do {} while statements
...
The octeon crypto co-processor expects values to be big endian.
Wrap the data transfers with cpu_to_be64() and be64_to_cpu()
transformations.
This passes for all the MD5 test vectors in crypto/testmgr.h
Signed-off-by: Paul Martin <paul.martin@codethink.co.uk>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/9631/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Don't disable bottom half while the crypto engine is in use, as it
should be unnecessary: All kernel crypto engine usage is wrapped with
crypto engine state save/restore, so if we get interrupted by softirq
that uses crypto they should save and restore our context.
This actually fixes an issue when running OCTEON MD5 with interrupts
disabled (tcrypt mode=302). There's a WARNING because the module is
trying to enable the bottom half with irqs disabled:
[ 52.656610] ------------[ cut here ]------------
[ 52.661439] WARNING: CPU: 1 PID: 428 at /home/aaro/git/linux/kernel/softirq.c:150 __local_bh_enable_ip+0x9c/0xd8()
[ 52.671780] Modules linked in: tcrypt(+)
[...]
[ 52.763539] [<ffffffff8114082c>] warn_slowpath_common+0x94/0xd8
[ 52.769465] [<ffffffff81144614>] __local_bh_enable_ip+0x9c/0xd8
[ 52.775390] [<ffffffff81119574>] octeon_md5_final+0x12c/0x1e8
[ 52.781144] [<ffffffff81337050>] shash_compat_digest+0xd0/0x1b0
Signed-off-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Cc: Herbert Xu <herbert@gondor.apana.org.au>
Cc: David S. Miller <davem@davemloft.net>
Cc: linux-crypto@vger.kernel.org
Cc: linux-mips@linux-mips.org
Cc: linux-kernel@vger.kernel.org
Patchwork: https://patchwork.linux-mips.org/patch/9490/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Add instruction definitions for SHA1/256/512.
Signed-off-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Always disable preemption on behalf of the drivers when crypto engine
is taken into use. This will simplify the usage.
Signed-off-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Don't disable bottom half while the crypto engine is in use, as it
should be unnecessary: All kernel crypto engine usage is wrapped with
crypto engine state save/restore, so if we get interrupted by softirq
that uses crypto they should save and restore our context.
This actually fixes an issue when running OCTEON MD5 with interrupts
disabled (tcrypt mode=302). There's a WARNING because the module is
trying to enable the bottom half with irqs disabled:
[ 52.656610] ------------[ cut here ]------------
[ 52.661439] WARNING: CPU: 1 PID: 428 at /home/aaro/git/linux/kernel/softirq.c:150 __local_bh_enable_ip+0x9c/0xd8()
[ 52.671780] Modules linked in: tcrypt(+)
[...]
[ 52.763539] [<ffffffff8114082c>] warn_slowpath_common+0x94/0xd8
[ 52.769465] [<ffffffff81144614>] __local_bh_enable_ip+0x9c/0xd8
[ 52.775390] [<ffffffff81119574>] octeon_md5_final+0x12c/0x1e8
[ 52.781144] [<ffffffff81337050>] shash_compat_digest+0xd0/0x1b0
Signed-off-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Add instruction definitions for MD5. Based on information extracted
from EdgeRouter Pro GPL source tarball.
Signed-off-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Add crypto helper functions which are needed for kernel level usage.
The code for these has been extracted from the EdgeRouter Pro GPL tarball.
While at it, also delete duplicate definitions of the functions.
Signed-off-by: Aaro Koskinen <aaro.koskinen@iki.fi>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Herbert Xu