This is a patch proposal to support shifted ranges in portmaps. (i.e. tcp/udp
incoming port 5000-5100 on WAN redirected to LAN 192.168.1.5:2000-2100)
Currently DNAT only works for single port or identical port ranges. (i.e.
ports 5000-5100 on WAN interface redirected to a LAN host while original
destination port is not altered) When different port ranges are configured,
either 'random' mode should be used, or else all incoming connections are
mapped onto the first port in the redirect range. (in described example
WAN:5000-5100 will all be mapped to 192.168.1.5:2000)
This patch introduces a new mode indicated by flag NF_NAT_RANGE_PROTO_OFFSET
which uses a base port value to calculate an offset with the destination port
present in the incoming stream. That offset is then applied as index within the
redirect port range (index modulo rangewidth to handle range overflow).
In described example the base port would be 5000. An incoming stream with
destination port 5004 would result in an offset value 4 which means that the
NAT'ed stream will be using destination port 2004.
Other possibilities include deterministic mapping of larger or multiple ranges
to a smaller range : WAN:5000-5999 -> LAN:5000-5099 (maps WAN port 5*xx to port
51xx)
This patch does not change any current behavior. It just adds new NAT proto
range functionality which must be selected via the specific flag when intended
to use.
A patch for iptables (libipt_DNAT.c + libip6t_DNAT.c) will also be proposed
which makes this functionality immediately available.
Signed-off-by: Thierry Du Tre <thierry@dtsystems.be>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
This patch is to remove the typedef sctp_sctphdr_t, and replace
with struct sctphdr in the places where it's using this typedef.
It is also to fix some indents and use sizeof(variable) instead
of sizeof(type).
Signed-off-by: Xin Long <lucien.xin@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Regarding RFC 792, the first 64 bits of the original SCTP datagram's
data could be contained in ICMP packet, such as:
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Code | Checksum |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| unused |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Internet Header + 64 bits of Original Data Datagram |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
However, according to RFC 4960, SCTP datagram header is as below:
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Source Port Number | Destination Port Number |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Verification Tag |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Checksum |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
It means only the first three fields of SCTP header can be carried in
ICMP packet except for Checksum field.
At present in sctp_manip_pkt(), no matter whether the packet is ICMP or
not, it always calculates SCTP packet checksum. However, not only the
calculation of checksum is unnecessary for ICMP, but also it causes
another fatal issue that ICMP packet is dropped. The header size of
SCTP is used to identify whether the writeable length of skb is bigger
than skb->len through skb_make_writable() in sctp_manip_pkt(). But
when it deals with ICMP packet, skb_make_writable() directly returns
false as the writeable length of skb is bigger than skb->len.
Subsequently ICMP is dropped.
Now we correct this misbahavior. When sctp_manip_pkt() handles ICMP
packet, 8 bytes rather than the whole SCTP header size is used to check
if writeable length of skb is overflowed. Meanwhile, as it's meaningless
to calculate checksum when packet is ICMP, the computation of checksum
is ignored as well.
Signed-off-by: Ying Xue <ying.xue@windriver.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
SCTP GSO and hardware can do CRC32c computation after netfilter processing,
so we can avoid calling sctp_compute_checksum() on skb if skb->ip_summed
is equal to CHECKSUM_PARTIAL. Moreover, set skb->ip_summed to CHECKSUM_NONE
when the NAT code computes the CRC, to prevent offloaders from computing
it again (on ixgbe this resulted in a transmission with wrong L4 checksum).
Signed-off-by: Davide Caratti <dcaratti@redhat.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
CONFIG_NF_NAT_PROTO_SCTP is no more a tristate. When set to y, NAT
support for SCTP protocol is built-in into nf_nat.ko.
footprint test:
(nf_nat_proto_) | sctp || nf_nat
--------------------------+--------++--------
no builtin | 428344 || 2241312
SCTP builtin | - || 2597032
Signed-off-by: Davide Caratti <dcaratti@redhat.com>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
This patch consolidates the SCTP checksum calculation code from various
places to a single new function, sctp_compute_cksum(skb, offset).
Signed-off-by: Joe Stringer <joe@wand.net.nz>
Reviewed-by: Julian Anastasov <ja@ssi.bg>
Acked-by: Simon Horman <horms@verge.net.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
Change the type of the crc32 parameter of sctp_end_cksum()
from __be32 to __u32 to reflect that fact that it is passed
to cpu_to_le32().
There are five in-tree users of sctp_end_cksum().
The following four had warnings flagged by sparse which are
no longer present with this change.
net/netfilter/ipvs/ip_vs_proto_sctp.c:sctp_nat_csum()
net/netfilter/ipvs/ip_vs_proto_sctp.c:sctp_csum_check()
net/sctp/input.c:sctp_rcv_checksum()
net/sctp/output.c:sctp_packet_transmit()
The fifth user is net/netfilter/nf_nat_proto_sctp.c:sctp_manip_pkt().
It has been updated to pass a __u32 instead of a __be32,
the value in question was already calculated in cpu byte-order.
net/netfilter/nf_nat_proto_sctp.c:sctp_manip_pkt() has also
been updated to assign the return value of sctp_end_cksum()
directly to a variable of type __le32, matching the
type of the return value. Previously the return value
was assigned to a variable of type __be32 and then that variable
was finally assigned to another variable of type __le32.
Problems flagged by sparse.
Compile and sparse tested only.
Signed-off-by: Simon Horman <horms@verge.net.au>
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Convert the IPv4 NAT implementation to a protocol independent core and
address family specific modules.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Thierry Du Tre