Unit addresses, whilst written in hex, don't contain a 0x prefix.
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Reviewed-by: Thierry Reding <thierry.reding@avionic-design.de>
Signed-off-by: Olof Johansson <olof@lixom.net>
For Seaboard, Ventana, and Cardhu, add DT property to tell the regulator
that it should provide the pm_power_off() implementation. This allows
"shutdown" to work.
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Seaboard uses a TPS6586x regulator. Instantiate this, and hook up a
couple of fixed GPIO-controlled regulators too.
Two data sources were used for the data encoded here:
* The HW defaults, as extracted from real HW.
* The schematic, which specifies a voltage for each LDO rail.
In most cases these sources matched. The only differences is:
ldo6: The HW default on Springbank is 2.85v. The HW default on Seaboard
is 1.8v. The schematics for both Springbank and Seaboard match at 2.85v.
However, internal research indicates that the schematics are incorrectly
labelled, and 1.8v is correct. The ChromeOS kernel also uses 1.8v.
Note that these settings don't entirely match those in the ChromeOS
kernel found at the URL below. However, the selected values generally
cause no behavior change in the kernel, and so were picked to avoid
regressions.
repo http://git.chromium.org/chromiumos/third_party/kernel.git
branch chromeos-3.2
file arch/arm/mach-tegra/board-seaboard-power.c
Portions based on work by Laxman Dewangan <ldewangan@nvidia.com>
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Tegra's I2C2 controller can be routed to either the PTA or DDC pin group
on Seaboard. Define the pinctrl state nodes required to allow runtime
control of this routing. Instantiate a pinctrl-i2cmux I2C bus mux that
uses these pinctrl states.
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Most ARM ${board}.dts files are already named ${soc}-${board}.dts. This
change modifies the Tegra board files to be named the same way for
consistency.
Once a related change is made in U-Boot, this will cause both U-Boot and
the kernel to use the same names for the .dts files and SoC identifiers,
thus allowing U-Boot's recently added "soc" and "board" environment
variables to be used to construct the name of Tegra .dtb files, and hence
allow board-generic U-Boot bootcmd scripts to be written.
Signed-off-by: Stephen Warren <swarren@nvidia.com>
2012-06-20 12:30:10 -06:00
Renamed from arch/arm/boot/dts/tegra-seaboard.dts (Browse further)
