dev->nr_luns reports the total number of luns available in a device
while dev->luns_per_chnl is the number of luns per channel.
When multiple channels are available, the offset is calculated from a
channel and lun id into a linear array. As it multiplies with
the total number of luns, we go out of bound when channel id > 0 and
causes the kernel to panic when we read a protected kernel memory area.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
The LightNVM module exposes a debug interface when CONFIG_NVM_DEBUG is
set. This interfaces takes a string to configure media managers and
targets. Make sure this interface is only exposed when chosen
deliberately.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
After the gennvm module has been initialized. It might be attached to
one or several devices. In that case, the module is in use. Make sure
that it can not be unloaded.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
This patch fixes two issues during media manager registration.
1. The ppa pool can be used at media manager registration. Allocate the
ppa pool before that.
2. If a media manager can't be found, this should not lead to the
device being unallocated. A media manager can be registered later, that
can manage the device. Only warn if a media manager fails
initialization.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
In the case where a request queue is passed to the low lever lightnvm
device drive integration, the device driver might pass its admin
commands through another queue. Instead pass nvm_dev, and let the
low level drive the appropriate queue.
Reported-by: Christoph Hellwig <hch@infradead.org>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
The spin_unlock is duplicated multiple times. Jump to a single unlock
to improve the code flow.
Signed-off-by: Wenwei Tao <ww.tao0320@gmail.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Put the allocated blocks back to the free list
when the luns configure failed, to make these
blocks useable to others.
Signed-off-by: Wenwei Tao <ww.tao0320@gmail.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
rrpc_get_blk use constant 0 as the input parameter
of nvm_get_blk, this may result in getting gc block
failed unexpectedly.
Signed-off-by: Wenwei Tao <ww.tao0320@gmail.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
To avoid race conditions, traverse dev, media manager,
and target lists and also register, unregister entries
to/from them, should be always under the nvm_lock control.
Signed-off-by: Wenwei Tao <ww.tao0320@gmail.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
The get_bb_tbl function takes ppa as a generic address, which is
converted to the ppa device address within the device driver. When
the update_bbtbl callback is called from get_bb_tbl, the device
specific ppa is used, instead of the generic ppa.
Make sure to pass the generic ppa.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
do device max_phys_sect boundary check first, otherwise
we will allocate dma_pools for devices whose max sectors
are beyond lightnvm support and register them.
Signed-off-by: Wenwei Tao <ww.tao0320@gmail.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
If copy_to_user() fails we returned error but we missed releasing
devices.
Signed-off-by: Sudip Mukherjee <sudip@vectorindia.org>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Add free block, used block, and bad block information to the show debug
interface. This information is used to debug how targets track blocks.
Also, change debug function name to make it more generic.
Signed-off-by: Javier Gonzalez <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Maintain number of in use blocks, free blocks, and bad blocks in a per
lun basis. This allows the upper layers to get information about the
state of each lun.
Also, account for blocks reserved to the device on the free block count.
nr_free_blocks matches now the actual number of blocks on the free list
when the device is booted.
Signed-off-by: Javier Gonzalez <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
If either max_phys_sect is out of bound, the nvm_dev structure is not
freed.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
The return value should be non-zero under error conditions.
Remove nvme_free(dev) to avoid free dev more than once.
Signed-off-by: Wenwei Tao <ww.tao0320@gmail.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
This prevents outstanding IOs to be sent for completion to target after
the target has been removed. The flow is now: stop new IOs > cleanup
queue > remove target.
Signed-off-by: Javier Gonzalez <javier@cnexlabs.com>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
The linear and device specific address modes can be replaced with a
simple offset and bit length conversion that is generic across all
devices.
This both simplifies the specification and removes the special case for
qemu nvme, that previously relied on the linear address mapping.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Both the nvm_register and nvm_init does a kfree(dev) on error. Make sure
to only free it once.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
We register with nvm_devices when there registration can still fail.
Move the final registration at the end of the nvm_register function
to make sure we are fully registered when added to the nvm_devices list.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Only NAND flash with SLC and MLC is supported. Make sure to not try to
initialize TLC memory or other non-volatile memory types.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
The specification was changed to reflect a multi-value bad block table.
Instead of bit-based bad block table, the bad block table now allows
eight bad block categories. Currently four are defined:
* Factory bad blocks
* Grown bad blocks
* Device-side reserved blocks
* Host-side reserved blocks
The factory and grown bad blocks are the regular bad blocks. The
reserved blocks are either for internal use or external use. In
particular, the device-side reserved blocks allows the host to
bootstrap from a limited number of flash blocks. Reducing the flash
blocks to scan upon super block initialization.
Support for both get bad block table and set bad block table is added.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
No functional changes in this patch, but it prepares us for returning
a more useful cookie related to the IO that was queued up.
Signed-off-by: Jens Axboe <axboe@fb.com>
Acked-by: Christoph Hellwig <hch@lst.de>
Acked-by: Keith Busch <keith.busch@intel.com>
For cases where CONFIG_LBDAF is not set. The struct ppa_addr exceeds its
type on 32 bit architectures. ppa_addr requires a 64bit integer to hold
the generic ppa format. We therefore refactor it to u64 and
replaces the sector_t usages with u64 for physical addresses.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
This target allows an Open-Channel SSD to be exposed asas a block
device.
It implements a round-robin approach for sector allocation,
together with a greedy cost-based garbage collector.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
The implementation for Open-Channel SSDs is divided into media
management and targets. This patch implements a generic media manager
for open-channel SSDs. After a media manager has been initialized,
single or multiple targets can be instantiated with the media managed as
the backend.
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Open-channel SSDs are devices that share responsibilities with the host
in order to implement and maintain features that typical SSDs keep
strictly in firmware. These include (i) the Flash Translation Layer
(FTL), (ii) bad block management, and (iii) hardware units such as the
flash controller, the interface controller, and large amounts of flash
chips. In this way, Open-channels SSDs exposes direct access to their
physical flash storage, while keeping a subset of the internal features
of SSDs.
LightNVM is a specification that gives support to Open-channel SSDs
LightNVM allows the host to manage data placement, garbage collection,
and parallelism. Device specific responsibilities such as bad block
management, FTL extensions to support atomic IOs, or metadata
persistence are still handled by the device.
The implementation of LightNVM consists of two parts: core and
(multiple) targets. The core implements functionality shared across
targets. This is initialization, teardown and statistics. The targets
implement the interface that exposes physical flash to user-space
applications. Examples of such targets include key-value store,
object-store, as well as traditional block devices, which can be
application-specific.
Contributions in this patch from:
Javier Gonzalez <jg@lightnvm.io>
Dongsheng Yang <yangds.fnst@cn.fujitsu.com>
Jesper Madsen <jmad@itu.dk>
Signed-off-by: Matias Bjørling <m@bjorling.me>
Signed-off-by: Jens Axboe <axboe@fb.com>
Matias Bjørling