138b15ed87
This howto made sense in the 1990s when users had to manually configure ISA cards with jumpers or vendor utilities, but with the implementation of PCI it became increasingly less and less relevant, to the point where it has been well over a decade since I last updated it. And there is no value in anyone else taking over updating it either. However the references to it continue to spread as boiler plate text from one Kconfig file into the next. We are not doing end users any favours by pointing them at this old document, so lets kill it with fire, once and for all, to hopefully stop any further spread. No code is changed in this commit, just Kconfig help text. Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com> Signed-off-by: David S. Miller <davem@davemloft.net>
34 lines
945 B
Plaintext
34 lines
945 B
Plaintext
#
|
|
# SEEQ device configuration
|
|
#
|
|
|
|
config NET_VENDOR_SEEQ
|
|
bool "SEEQ devices"
|
|
default y
|
|
depends on HAS_IOMEM
|
|
---help---
|
|
If you have a network (Ethernet) card belonging to this class, say Y.
|
|
|
|
Note that the answer to this question doesn't directly affect the
|
|
kernel: saying N will just cause the configurator to skip all
|
|
the questions about SEEQ devices. If you say Y, you will be asked for
|
|
your specific card in the following questions.
|
|
|
|
if NET_VENDOR_SEEQ
|
|
|
|
config ARM_ETHER3
|
|
tristate "Acorn/ANT Ether3 support"
|
|
depends on ARM && ARCH_ACORN
|
|
---help---
|
|
If you have an Acorn system with one of these network cards, you
|
|
should say Y to this option if you wish to use it with Linux.
|
|
|
|
config SGISEEQ
|
|
tristate "SGI Seeq ethernet controller support"
|
|
depends on SGI_HAS_SEEQ
|
|
---help---
|
|
Say Y here if you have an Seeq based Ethernet network card. This is
|
|
used in many Silicon Graphics machines.
|
|
|
|
endif # NET_VENDOR_SEEQ
|