ab92ffd5f6
Drop the doubled word "for". Change "It it" to "If it". Signed-off-by: Randy Dunlap <rdunlap@infradead.org> Cc: linux-pm@vger.kernel.org Acked-by: Pali Rohár <pali@kernel.org> Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
46 lines
1.4 KiB
C
46 lines
1.4 KiB
C
/* SPDX-License-Identifier: GPL-2.0-or-later */
|
|
/*
|
|
* bq2415x charger driver
|
|
*
|
|
* Copyright (C) 2011-2013 Pali Rohár <pali@kernel.org>
|
|
*/
|
|
|
|
#ifndef BQ2415X_CHARGER_H
|
|
#define BQ2415X_CHARGER_H
|
|
|
|
/*
|
|
* This is platform data for bq2415x chip. It contains default board
|
|
* voltages and currents which can be also later configured via sysfs. If
|
|
* value is -1 then default chip value (specified in datasheet) will be
|
|
* used.
|
|
*
|
|
* Value resistor_sense is needed for configuring charge and
|
|
* termination current. If it is less or equal to zero, configuring charge
|
|
* and termination current will not be possible.
|
|
*
|
|
* For automode support is needed to provide name of power supply device
|
|
* in value notify_device. Device driver must immediately report property
|
|
* POWER_SUPPLY_PROP_CURRENT_MAX when current changed.
|
|
*/
|
|
|
|
/* Supported modes with maximal current limit */
|
|
enum bq2415x_mode {
|
|
BQ2415X_MODE_OFF, /* offline mode (charger disabled) */
|
|
BQ2415X_MODE_NONE, /* unknown charger (100mA) */
|
|
BQ2415X_MODE_HOST_CHARGER, /* usb host/hub charger (500mA) */
|
|
BQ2415X_MODE_DEDICATED_CHARGER, /* dedicated charger (unlimited) */
|
|
BQ2415X_MODE_BOOST, /* boost mode (charging disabled) */
|
|
};
|
|
|
|
struct bq2415x_platform_data {
|
|
int current_limit; /* mA */
|
|
int weak_battery_voltage; /* mV */
|
|
int battery_regulation_voltage; /* mV */
|
|
int charge_current; /* mA */
|
|
int termination_current; /* mA */
|
|
int resistor_sense; /* m ohm */
|
|
const char *notify_device; /* name */
|
|
};
|
|
|
|
#endif
|