redonkable/alistair23-linux
redonkable/alistair23-linux
1
0
Fork 0
Code Releases Activity
alistair23-linux/arch/arc/kernel/entry-arcv2.S
Yuriy Kolerov f33b8cddc8 ARCv2: intc: Rework the build time irq count information 
Currently Kconfig knob ARC_NUMBER_OF_INTERRUPTS is used as indicator of
hard irq count. But it is flawed that it doesn't affect
 - NR_IRQS     : for number of virtual interrupts
 - NR_CPU_IRQS : for number of hardware interrupts

Moreover the actual hardware irq count might still not be same as
ARC_NUMBER_OF_INTERRUPTS. So use the information availble in the
Build Configuration Registers and get rid of the Kconfig option.

We still need "some" build time info about irq count to set up
sufficient number of vector table entries. This is done with a
sufficiently large NR_CPU_IRQS which will eventually be used soley for
that purpose (subsequent patches will remove its usage elsewhere)

So to summarize what this patch does:

  * NR_CPU_IRQS defines a maximum number of hardware interrupts.
  * Remove ARC_NUMBER_OF_INTERRUPTS option and create interrupts
    table for all possible hardware interrupts.
  * Increase a maximum number of virtual IRQs to 512. ARCv2 can
    support 240 interrupts in the core interrupts controllers
    and 128 interrupts in IDU. Thus 512 virtual IRQs must be
    enough for most configurations of boards.

This patch leads to NR_CPU_IRQS in 2 places, to reduce the overall
churn. The next patch will remove the 2nd definition anyways.

Signed-off-by: Yuriy Kolerov <yuriy.kolerov@synopsys.com>
Signed-off-by: Vineet Gupta <vgupta@synopsys.com>
[vgupta: reworked the changelog a bit]
2017-02-06 09:37:57 -08:00

297 lines
7.7 KiB
ArmAsm
Raw Blame History

/*
* ARCv2 ISA based core Low Level Intr/Traps/Exceptions(non-TLB) Handling
*
* Copyright (C) 2013 Synopsys, Inc. (www.synopsys.com)
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/linkage.h> /* ARC_{EXTRY,EXIT} */
#include <asm/entry.h> /* SAVE_ALL_{INT1,INT2,TRAP...} */
#include <asm/errno.h>
#include <asm/arcregs.h>
#include <asm/irqflags.h>
; A maximum number of supported interrupts in the core interrupt controller.
; This number is not equal to the maximum interrupt number (256) because
; first 16 lines are reserved for exceptions and are not configurable.
#define NR_CPU_IRQS 240
.cpu HS
#define VECTOR .word
;############################ Vector Table #################################
.section .vector,"a",@progbits
.align 4
# Initial 16 slots are Exception Vectors
VECTOR res_service ; Reset Vector
VECTOR mem_service ; Mem exception
VECTOR instr_service ; Instrn Error
VECTOR EV_MachineCheck ; Fatal Machine check
VECTOR EV_TLBMissI ; Intruction TLB miss
VECTOR EV_TLBMissD ; Data TLB miss
VECTOR EV_TLBProtV ; Protection Violation
VECTOR EV_PrivilegeV ; Privilege Violation
VECTOR EV_SWI ; Software Breakpoint
VECTOR EV_Trap ; Trap exception
VECTOR EV_Extension ; Extn Instruction Exception
VECTOR EV_DivZero ; Divide by Zero
VECTOR EV_DCError ; Data Cache Error
VECTOR EV_Misaligned ; Misaligned Data Access
VECTOR reserved ; Reserved slots
VECTOR reserved ; Reserved slots
# Begin Interrupt Vectors
VECTOR handle_interrupt ; (16) Timer0
VECTOR handle_interrupt ; unused (Timer1)
VECTOR handle_interrupt ; unused (WDT)
VECTOR handle_interrupt ; (19) Inter core Interrupt (IPI)
VECTOR handle_interrupt ; (20) perf Interrupt
VECTOR handle_interrupt ; (21) Software Triggered Intr (Self IPI)
VECTOR handle_interrupt ; unused
VECTOR handle_interrupt ; (23) unused
# End of fixed IRQs
.rept NR_CPU_IRQS - 8
VECTOR handle_interrupt
.endr
.section .text, "ax",@progbits
reserved:
flag 1 ; Unexpected event, halt
;##################### Interrupt Handling ##############################
ENTRY(handle_interrupt)
INTERRUPT_PROLOGUE irq
# irq control APIs local_irq_save/restore/disable/enable fiddle with
# global interrupt enable bits in STATUS32 (.IE for 1 prio, .E[] for 2 prio)
# However a taken interrupt doesn't clear these bits. Thus irqs_disabled()
# query in hard ISR path would return false (since .IE is set) which would
# trips genirq interrupt handling asserts.
#
# So do a "soft" disable of interrutps here.
#
# Note this disable is only for consistent book-keeping as further interrupts
# will be disabled anyways even w/o this. Hardware tracks active interrupts
# seperately in AUX_IRQ_ACTIVE.active and will not take new interrupts
# unless this one returns (or higher prio becomes pending in 2-prio scheme)
IRQ_DISABLE
; icause is banked: one per priority level
; so a higher prio interrupt taken here won't clobber prev prio icause
lr r0, [ICAUSE]
mov blink, ret_from_exception
b.d arch_do_IRQ
mov r1, sp
END(handle_interrupt)
;################### Non TLB Exception Handling #############################
ENTRY(EV_SWI)
flag 1
END(EV_SWI)
ENTRY(EV_DivZero)
flag 1
END(EV_DivZero)
ENTRY(EV_DCError)
flag 1
END(EV_DCError)
; ---------------------------------------------
; Memory Error Exception Handler
; - Unlike ARCompact, handles Bus errors for both User/Kernel mode,
; Instruction fetch or Data access, under a single Exception Vector
; ---------------------------------------------
ENTRY(mem_service)
EXCEPTION_PROLOGUE
lr r0, [efa]
mov r1, sp
FAKE_RET_FROM_EXCPN
bl do_memory_error
b ret_from_exception
END(mem_service)
ENTRY(EV_Misaligned)
EXCEPTION_PROLOGUE
lr r0, [efa] ; Faulting Data address
mov r1, sp
FAKE_RET_FROM_EXCPN
SAVE_CALLEE_SAVED_USER
mov r2, sp ; callee_regs
bl do_misaligned_access
; TBD: optimize - do this only if a callee reg was involved
; either a dst of emulated LD/ST or src with address-writeback
RESTORE_CALLEE_SAVED_USER
b ret_from_exception
END(EV_Misaligned)
; ---------------------------------------------
; Protection Violation Exception Handler
; ---------------------------------------------
ENTRY(EV_TLBProtV)
EXCEPTION_PROLOGUE
lr r0, [efa] ; Faulting Data address
mov r1, sp ; pt_regs
FAKE_RET_FROM_EXCPN
mov blink, ret_from_exception
b do_page_fault
END(EV_TLBProtV)
; From Linux standpoint Slow Path I/D TLB Miss is same a ProtV as they
; need to call do_page_fault().
; ECR in pt_regs provides whether access was R/W/X
.global call_do_page_fault
.set call_do_page_fault, EV_TLBProtV
;############# Common Handlers for ARCompact and ARCv2 ##############
#include "entry.S"
;############# Return from Intr/Excp/Trap (ARCv2 ISA Specifics) ##############
;
; Restore the saved sys context (common exit-path for EXCPN/IRQ/Trap)
; IRQ shd definitely not happen between now and rtie
; All 2 entry points to here already disable interrupts
.Lrestore_regs:
restore_regs:
# Interrpts are actually disabled from this point on, but will get
# reenabled after we return from interrupt/exception.
# But irq tracer needs to be told now...
TRACE_ASM_IRQ_ENABLE
ld r0, [sp, PT_status32] ; U/K mode at time of entry
lr r10, [AUX_IRQ_ACT]
bmsk r11, r10, 15 ; AUX_IRQ_ACT.ACTIVE
breq r11, 0, .Lexcept_ret ; No intr active, ret from Exception
;####### Return from Intr #######
debug_marker_l1:
bbit1.nt r0, STATUS_DE_BIT, .Lintr_ret_to_delay_slot
.Lisr_ret_fast_path:
; Handle special case #1: (Entry via Exception, Return via IRQ)
;
; Exception in U mode, preempted in kernel, Intr taken (K mode), orig
; task now returning to U mode (riding the Intr)
; AUX_IRQ_ACTIVE won't have U bit set (since intr in K mode), hence SP
; won't be switched to correct U mode value (from AUX_SP)
; So force AUX_IRQ_ACT.U for such a case
btst r0, STATUS_U_BIT ; Z flag set if K (Z clear for U)
bset.nz r11, r11, AUX_IRQ_ACT_BIT_U ; NZ means U
sr r11, [AUX_IRQ_ACT]
INTERRUPT_EPILOGUE irq
rtie
;####### Return from Exception / pure kernel mode #######
.Lexcept_ret: ; Expects r0 has PT_status32
debug_marker_syscall:
EXCEPTION_EPILOGUE
rtie
;####### Return from Intr to insn in delay slot #######
; Handle special case #2: (Entry via Exception in Delay Slot, Return via IRQ)
;
; Intr returning to a Delay Slot (DS) insn
; (since IRQ NOT allowed in DS in ARCv2, this can only happen if orig
; entry was via Exception in DS which got preempted in kernel).
;
; IRQ RTIE won't reliably restore DE bit and/or BTA, needs workaround
;
; Solution is return from Intr w/o any delay slot quirks into a kernel trampoline
; and from pure kernel mode return to delay slot which handles DS bit/BTA correctly
.Lintr_ret_to_delay_slot:
debug_marker_ds:
ld r2, [@intr_to_DE_cnt]
add r2, r2, 1
st r2, [@intr_to_DE_cnt]
ld r2, [sp, PT_ret]
ld r3, [sp, PT_status32]
; STAT32 for Int return created from scratch
; (No delay dlot, disable Further intr in trampoline)
bic r0, r3, STATUS_U_MASK|STATUS_DE_MASK|STATUS_IE_MASK|STATUS_L_MASK
st r0, [sp, PT_status32]
mov r1, .Lintr_ret_to_delay_slot_2
st r1, [sp, PT_ret]
; Orig exception PC/STAT32 safekept @orig_r0 and @event stack slots
st r2, [sp, 0]
st r3, [sp, 4]
b .Lisr_ret_fast_path
.Lintr_ret_to_delay_slot_2:
; Trampoline to restore orig exception PC/STAT32/BTA/AUX_USER_SP
sub sp, sp, SZ_PT_REGS
st r9, [sp, -4]
ld r9, [sp, 0]
sr r9, [eret]
ld r9, [sp, 4]
sr r9, [erstatus]
; restore AUX_USER_SP if returning to U mode
bbit0 r9, STATUS_U_BIT, 1f
ld r9, [sp, PT_sp]
sr r9, [AUX_USER_SP]
1:
ld r9, [sp, 8]
sr r9, [erbta]
ld r9, [sp, -4]
add sp, sp, SZ_PT_REGS
; return from pure kernel mode to delay slot
rtie
END(ret_from_exception)
View git blame Copy permalink