redonkable
/
alistair23-linux
1
0
Fork 0
Code Releases Activity
alistair23-linux/drivers/staging/iio
History
Greg Kroah-Hartman ec3c13e4ac Third set of IIO new device support, features and cleanups for the 4.6 cycle. 
Good to see several new contributors in this set - and more generally a
 number of new 'faces' over this whole cycle.
 
 Staging movements
 * hmc5843
   - out of staging.
 * periodic RTC trigger
   - driver dropped.  This is an ancient driver (brings back some memories ;)
   that was always somewhat of a bodge. Originally there was a driver that
   never went into mainline that supported large numbers of periodict timers
   on the PXA270 via this route. Discussions to have a generic periodic
   timer subsystem never went anywhere.  At the time RTC periodic
   interrupts were real - now they are emulated using high resolution
   timers so with the HRT driver this has become pointless.
 
 New device support
 * mpu6050 driver
   - Add support for the mpu6500.
 * TI tpl0102 potentiometer
   - new driver.
 * Vybrid SoC DAC
   - new driver.  The ADC on this SoC has been supported for a while, this
     adds a separate driver for the DAC.
 
 New Features
 * hmc5844
   - Attributes to configure the bias current (typically part of a self test)
     This could be done before via a somewhat obscure custom interface.
     This at least makes it easy to tell what is going on.
   - Document all custom attributes.
 * mpu6050
   - Add support for calibration offset control and readback.
 * ms5611
   - power regulator support.  This is always one that gets added the
     first time someone has a board that needs it.  Here it was needed,
     hence it was added.
 
 Cleanups / minor fixes
 * tree wide
   - clean up all the myriad different return values in response to a
     failure of i2c_check_functionality.  After discussions everyone seemed
     happy wiht -EOPNOTSUPP which seems to describe the situation well.
     I encouraged a tree wide cleanup to set a good example in future for
     this.
 * core
   - Typos in the iio_event_spec documentation in iio.h
 * afe4403
   - select REGMAP_SPI to avoid dependency issues
   - mark suspend/resume as __maybe_unused to avoid warnings
 * afe4404
   - mark suspend/resume as __maybe_unused to avoid warnings
 * atlas-ph-sensor
   - switch the regmap cache type from linear to rbtree to gain reading of
     registers on initial startup.  It's not immediately obvious, but
     regmap flat is meant for high performances cases so doesn't read these
     registers.
   - use regmap_bulk_read in one case where it was using
     i2c_smbus_read_i2c_block_data directly (unlike everything else that was
     through regmap).
 * ina2xx
   - stype cleanups (lots of them!)
 * isl29018
   - Get the struct device back from regmap rather than storing another
     copy of it in the private data.  This cleanup makes sense in a number
     of other drivers so patches may well follow.
 * mpu6050
   - style cleanups (lots of them!)
   - improved return value handling
   - use usleep_range to avoid the usual issues with very short msleeps.
   - add some missing documentation.
 * ms5611
   - use the probed device name for the device rather than the driver name.
   - select IIO_BUFFER to avoid dependency issues
 * palmas
   - drop IRQF_EARLY_RESUME as no longer needed after genirq changes.
 -----BEGIN PGP SIGNATURE-----
 Version: GnuPG v2
 
 iQIcBAABCAAGBQJW0ygBAAoJEFSFNJnE9BaIJDQP/RpVwCxgxgUi0QyuLFAfQ0Ab
 FJFZznvmK6aGtGBAt/uKwBD5K/JcX9zGgm82j10+rVCtnLxFmusNXB180jUjvknu
 ZAEzJ58IWX+FqEsbVUZsx8qpef+yCCLP/HHvyctqXhtVTrlVlyoGSfn6+xzP3766
 PxkXpdWSd3IEdITYZrZo7BsZ6h6Tjz9c4i40f3RdnEce48nNnzM5IKMNbvU2puRs
 NxGDXflKKkA5N4uIW2n6pLxIyyW/LdwChmHkR+U7dxxj3/wUK9BC46qvhyqtgC3I
 U6uYCI+p2up22bfQsZ+p/CKRRhhrOtBs9//wSMapK96CVbI3HGcJLZP1yJENwfW8
 5sWEypaZNlpZVnjtREQpk5oz2hOsunxI+7FHSqUjLe+wwON79WXVFZz2qx3NcIle
 YPZFIQiYZTVauE/PsPy22I2vBoHxpgsD+A8M1d4+nQAH8SkRqvnnu5WVgd3ftm/u
 kXUjj+s+M1Pn84EIWYlEaIypAnhaNgIDW8M269rRdC0hH6yAxjJ9PXm45TGcRxr/
 qmkUKfD5wfPgE3FwYoyH8da22dc7dRSgLdizxtSS7rInmFH1HJ3xb566VszXsPVH
 tJjM2KtIC16czGUh5V+MmCpdSfOT1wR0wFPdUhGoJGm7sGkTsuoQRkQzgHwJM/aF
 ITuCZWLR/2YXw0bx4MKM
 =rDIQ
 -----END PGP SIGNATURE-----

Merge tag 'iio-for-4.6c' of git://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio into staging-next

Jonathan writes:

Third set of IIO new device support, features and cleanups for the 4.6 cycle.

Good to see several new contributors in this set - and more generally a
number of new 'faces' over this whole cycle.

Staging movements
* hmc5843
  - out of staging.
* periodic RTC trigger
  - driver dropped.  This is an ancient driver (brings back some memories ;)
  that was always somewhat of a bodge. Originally there was a driver that
  never went into mainline that supported large numbers of periodict timers
  on the PXA270 via this route. Discussions to have a generic periodic
  timer subsystem never went anywhere.  At the time RTC periodic
  interrupts were real - now they are emulated using high resolution
  timers so with the HRT driver this has become pointless.

New device support
* mpu6050 driver
  - Add support for the mpu6500.
* TI tpl0102 potentiometer
  - new driver.
* Vybrid SoC DAC
  - new driver.  The ADC on this SoC has been supported for a while, this
    adds a separate driver for the DAC.

New Features
* hmc5844
  - Attributes to configure the bias current (typically part of a self test)
    This could be done before via a somewhat obscure custom interface.
    This at least makes it easy to tell what is going on.
  - Document all custom attributes.
* mpu6050
  - Add support for calibration offset control and readback.
* ms5611
  - power regulator support.  This is always one that gets added the
    first time someone has a board that needs it.  Here it was needed,
    hence it was added.

Cleanups / minor fixes
* tree wide
  - clean up all the myriad different return values in response to a
    failure of i2c_check_functionality.  After discussions everyone seemed
    happy wiht -EOPNOTSUPP which seems to describe the situation well.
    I encouraged a tree wide cleanup to set a good example in future for
    this.
* core
  - Typos in the iio_event_spec documentation in iio.h
* afe4403
  - select REGMAP_SPI to avoid dependency issues
  - mark suspend/resume as __maybe_unused to avoid warnings
* afe4404
  - mark suspend/resume as __maybe_unused to avoid warnings
* atlas-ph-sensor
  - switch the regmap cache type from linear to rbtree to gain reading of
    registers on initial startup.  It's not immediately obvious, but
    regmap flat is meant for high performances cases so doesn't read these
    registers.
  - use regmap_bulk_read in one case where it was using
    i2c_smbus_read_i2c_block_data directly (unlike everything else that was
    through regmap).
* ina2xx
  - stype cleanups (lots of them!)
* isl29018
  - Get the struct device back from regmap rather than storing another
    copy of it in the private data.  This cleanup makes sense in a number
    of other drivers so patches may well follow.
* mpu6050
  - style cleanups (lots of them!)
  - improved return value handling
  - use usleep_range to avoid the usual issues with very short msleeps.
  - add some missing documentation.
* ms5611
  - use the probed device name for the device rather than the driver name.
  - select IIO_BUFFER to avoid dependency issues
* palmas
  - drop IRQF_EARLY_RESUME as no longer needed after genirq changes.
 		2016-03-01 16:31:55 -08:00
..
Documentation Staging: iio: Documentation: Remove unused sysfs attributes 2016-01-30 16:27:11 +00:00
accel staging: iio: accel: Remove unnecessary else after goto in if block 2016-02-20 14:45:05 -08:00
adc staging: iio: adc: Remove unnecessary test from if conditions 2016-02-20 14:43:48 -08:00
addac spi: Updates for v4.4 2015-11-05 13:15:12 -08:00
cdc staging: iio: Remove parentheses on the right hand side of assignment 2016-02-11 19:37:15 -08:00
frequency Staging: iio: frequency: use dev_get_platdata() 2015-12-02 18:42:06 +00:00
gyro spi: Updates for v4.4 2015-11-05 13:15:12 -08:00
impedance-analyzer Staging:iio:Remove exceptional & on function name 2016-02-06 18:07:04 +00:00
light Third set of IIO new device support, features and cleanups for the 4.6 cycle. 2016-03-01 16:31:55 -08:00
meter iio: ade7753: avoid uninitialized data 2016-01-30 16:24:24 +00:00
resolver staging: iio: resolver: fix comparison to NULL 2016-02-20 14:46:35 -08:00
trigger staging:iio: Remove periodic RTC trigger driver 2016-02-27 17:18:38 +00:00
Kconfig iio: hmc5843: Move hmc5843 out of staging 2016-02-24 20:40:39 +00:00
Makefile iio: hmc5843: Move hmc5843 out of staging 2016-02-24 20:40:39 +00:00
TODO staging:iio: Remove periodic RTC trigger driver 2016-02-27 17:18:38 +00:00
ring_hw.h staging: iio: Add #include guards to header files 2014-09-28 22:19:04 -04:00