791d3ef2e1
'interrupt-parent' is often documented as part of define bindings, but it is really outside the scope of a device binding. It's never required in a given node as it is often inherited from a parent node. Or it can be implicit if a parent node is an 'interrupt-controller' node. So remove it from all the binding files. Cc: Mark Rutland <mark.rutland@arm.com> Cc: devicetree@vger.kernel.org Signed-off-by: Rob Herring <robh@kernel.org>
35 lines
990 B
Plaintext
35 lines
990 B
Plaintext
Elantech I2C Touchscreen
|
|
|
|
Required properties:
|
|
- compatible: must be "elan,ekth3500".
|
|
- reg: I2C address of the chip.
|
|
- interrupts: interrupt to which the chip is connected (see interrupt
|
|
binding[0]).
|
|
|
|
Optional properties:
|
|
- wakeup-source: touchscreen can be used as a wakeup source.
|
|
- pinctrl-names: should be "default" (see pinctrl binding [1]).
|
|
- pinctrl-0: a phandle pointing to the pin settings for the device (see
|
|
pinctrl binding [1]).
|
|
- reset-gpios: reset gpio the chip is connected to.
|
|
- vcc33-supply: a phandle for the regulator supplying 3.3V power.
|
|
- vccio-supply: a phandle for the regulator supplying IO power.
|
|
|
|
[0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
|
|
[1]: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
|
|
|
|
Example:
|
|
&i2c1 {
|
|
/* ... */
|
|
|
|
touchscreen@10 {
|
|
compatible = "elan,ekth3500";
|
|
reg = <0x10>;
|
|
interrupt-parent = <&gpio4>;
|
|
interrupts = <0x0 IRQ_TYPE_EDGE_FALLING>;
|
|
wakeup-source;
|
|
};
|
|
|
|
/* ... */
|
|
};
|