alistair23-linux/arch/arm64/mm/init.c
Santosh Shilimkar 374d5c9964 of: Specify initrd location using 64-bit
On some PAE architectures, the entire range of physical memory could reside
outside the 32-bit limit.  These systems need the ability to specify the
initrd location using 64-bit numbers.

This patch globally modifies the early_init_dt_setup_initrd_arch() function to
use 64-bit numbers instead of the current unsigned long.

There has been quite a bit of debate about whether to use u64 or phys_addr_t.
It was concluded to stick to u64 to be consistent with rest of the device
tree code. As summarized by Geert, "The address to load the initrd is decided
by the bootloader/user and set at that point later in time. The dtb should not
be tied to the kernel you are booting"

More details on the discussion can be found here:
https://lkml.org/lkml/2013/6/20/690
https://lkml.org/lkml/2012/9/13/544

Signed-off-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Acked-by: Rob Herring <rob.herring@calxeda.com>
Acked-by: Vineet Gupta <vgupta@synopsys.com>
Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Grant Likely <grant.likely@linaro.org>
2013-07-24 11:10:01 +01:00

359 lines
9 KiB
C

/*
* Based on arch/arm/mm/init.c
*
* Copyright (C) 1995-2005 Russell King
* Copyright (C) 2012 ARM Ltd.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <http://www.gnu.org/licenses/>.
*/
#include <linux/kernel.h>
#include <linux/export.h>
#include <linux/errno.h>
#include <linux/swap.h>
#include <linux/init.h>
#include <linux/bootmem.h>
#include <linux/mman.h>
#include <linux/nodemask.h>
#include <linux/initrd.h>
#include <linux/gfp.h>
#include <linux/memblock.h>
#include <linux/sort.h>
#include <linux/of_fdt.h>
#include <asm/prom.h>
#include <asm/sections.h>
#include <asm/setup.h>
#include <asm/sizes.h>
#include <asm/tlb.h>
#include "mm.h"
static unsigned long phys_initrd_start __initdata = 0;
static unsigned long phys_initrd_size __initdata = 0;
phys_addr_t memstart_addr __read_mostly = 0;
void __init early_init_dt_setup_initrd_arch(u64 start, u64 end)
{
phys_initrd_start = start;
phys_initrd_size = end - start;
}
static int __init early_initrd(char *p)
{
unsigned long start, size;
char *endp;
start = memparse(p, &endp);
if (*endp == ',') {
size = memparse(endp + 1, NULL);
phys_initrd_start = start;
phys_initrd_size = size;
}
return 0;
}
early_param("initrd", early_initrd);
#define MAX_DMA32_PFN ((4UL * 1024 * 1024 * 1024) >> PAGE_SHIFT)
static void __init zone_sizes_init(unsigned long min, unsigned long max)
{
struct memblock_region *reg;
unsigned long zone_size[MAX_NR_ZONES], zhole_size[MAX_NR_ZONES];
unsigned long max_dma32 = min;
memset(zone_size, 0, sizeof(zone_size));
#ifdef CONFIG_ZONE_DMA32
/* 4GB maximum for 32-bit only capable devices */
max_dma32 = max(min, min(max, MAX_DMA32_PFN));
zone_size[ZONE_DMA32] = max_dma32 - min;
#endif
zone_size[ZONE_NORMAL] = max - max_dma32;
memcpy(zhole_size, zone_size, sizeof(zhole_size));
for_each_memblock(memory, reg) {
unsigned long start = memblock_region_memory_base_pfn(reg);
unsigned long end = memblock_region_memory_end_pfn(reg);
if (start >= max)
continue;
#ifdef CONFIG_ZONE_DMA32
if (start < max_dma32) {
unsigned long dma_end = min(end, max_dma32);
zhole_size[ZONE_DMA32] -= dma_end - start;
}
#endif
if (end > max_dma32) {
unsigned long normal_end = min(end, max);
unsigned long normal_start = max(start, max_dma32);
zhole_size[ZONE_NORMAL] -= normal_end - normal_start;
}
}
free_area_init_node(0, zone_size, min, zhole_size);
}
#ifdef CONFIG_HAVE_ARCH_PFN_VALID
int pfn_valid(unsigned long pfn)
{
return memblock_is_memory(pfn << PAGE_SHIFT);
}
EXPORT_SYMBOL(pfn_valid);
#endif
#ifndef CONFIG_SPARSEMEM
static void arm64_memory_present(void)
{
}
#else
static void arm64_memory_present(void)
{
struct memblock_region *reg;
for_each_memblock(memory, reg)
memory_present(0, memblock_region_memory_base_pfn(reg),
memblock_region_memory_end_pfn(reg));
}
#endif
void __init arm64_memblock_init(void)
{
u64 *reserve_map, base, size;
/* Register the kernel text, kernel data and initrd with memblock */
memblock_reserve(__pa(_text), _end - _text);
#ifdef CONFIG_BLK_DEV_INITRD
if (phys_initrd_size) {
memblock_reserve(phys_initrd_start, phys_initrd_size);
/* Now convert initrd to virtual addresses */
initrd_start = __phys_to_virt(phys_initrd_start);
initrd_end = initrd_start + phys_initrd_size;
}
#endif
/*
* Reserve the page tables. These are already in use,
* and can only be in node 0.
*/
memblock_reserve(__pa(swapper_pg_dir), SWAPPER_DIR_SIZE);
memblock_reserve(__pa(idmap_pg_dir), IDMAP_DIR_SIZE);
/* Reserve the dtb region */
memblock_reserve(virt_to_phys(initial_boot_params),
be32_to_cpu(initial_boot_params->totalsize));
/*
* Process the reserve map. This will probably overlap the initrd
* and dtb locations which are already reserved, but overlapping
* doesn't hurt anything
*/
reserve_map = ((void*)initial_boot_params) +
be32_to_cpu(initial_boot_params->off_mem_rsvmap);
while (1) {
base = be64_to_cpup(reserve_map++);
size = be64_to_cpup(reserve_map++);
if (!size)
break;
memblock_reserve(base, size);
}
memblock_allow_resize();
memblock_dump_all();
}
void __init bootmem_init(void)
{
unsigned long min, max;
min = PFN_UP(memblock_start_of_DRAM());
max = PFN_DOWN(memblock_end_of_DRAM());
/*
* Sparsemem tries to allocate bootmem in memory_present(), so must be
* done after the fixed reservations.
*/
arm64_memory_present();
sparse_init();
zone_sizes_init(min, max);
high_memory = __va((max << PAGE_SHIFT) - 1) + 1;
max_pfn = max_low_pfn = max;
}
#ifndef CONFIG_SPARSEMEM_VMEMMAP
static inline void free_memmap(unsigned long start_pfn, unsigned long end_pfn)
{
struct page *start_pg, *end_pg;
unsigned long pg, pgend;
/*
* Convert start_pfn/end_pfn to a struct page pointer.
*/
start_pg = pfn_to_page(start_pfn - 1) + 1;
end_pg = pfn_to_page(end_pfn - 1) + 1;
/*
* Convert to physical addresses, and round start upwards and end
* downwards.
*/
pg = (unsigned long)PAGE_ALIGN(__pa(start_pg));
pgend = (unsigned long)__pa(end_pg) & PAGE_MASK;
/*
* If there are free pages between these, free the section of the
* memmap array.
*/
if (pg < pgend)
free_bootmem(pg, pgend - pg);
}
/*
* The mem_map array can get very big. Free the unused area of the memory map.
*/
static void __init free_unused_memmap(void)
{
unsigned long start, prev_end = 0;
struct memblock_region *reg;
for_each_memblock(memory, reg) {
start = __phys_to_pfn(reg->base);
#ifdef CONFIG_SPARSEMEM
/*
* Take care not to free memmap entries that don't exist due
* to SPARSEMEM sections which aren't present.
*/
start = min(start, ALIGN(prev_end, PAGES_PER_SECTION));
#endif
/*
* If we had a previous bank, and there is a space between the
* current bank and the previous, free it.
*/
if (prev_end && prev_end < start)
free_memmap(prev_end, start);
/*
* Align up here since the VM subsystem insists that the
* memmap entries are valid from the bank end aligned to
* MAX_ORDER_NR_PAGES.
*/
prev_end = ALIGN(start + __phys_to_pfn(reg->size),
MAX_ORDER_NR_PAGES);
}
#ifdef CONFIG_SPARSEMEM
if (!IS_ALIGNED(prev_end, PAGES_PER_SECTION))
free_memmap(prev_end, ALIGN(prev_end, PAGES_PER_SECTION));
#endif
}
#endif /* !CONFIG_SPARSEMEM_VMEMMAP */
/*
* mem_init() marks the free areas in the mem_map and tells us how much memory
* is free. This is done after various parts of the system have claimed their
* memory after the kernel image.
*/
void __init mem_init(void)
{
arm64_swiotlb_init();
max_mapnr = pfn_to_page(max_pfn + PHYS_PFN_OFFSET) - mem_map;
#ifndef CONFIG_SPARSEMEM_VMEMMAP
free_unused_memmap();
#endif
/* this will put all unused low memory onto the freelists */
free_all_bootmem();
mem_init_print_info(NULL);
#define MLK(b, t) b, t, ((t) - (b)) >> 10
#define MLM(b, t) b, t, ((t) - (b)) >> 20
#define MLK_ROUNDUP(b, t) b, t, DIV_ROUND_UP(((t) - (b)), SZ_1K)
pr_notice("Virtual kernel memory layout:\n"
" vmalloc : 0x%16lx - 0x%16lx (%6ld MB)\n"
#ifdef CONFIG_SPARSEMEM_VMEMMAP
" vmemmap : 0x%16lx - 0x%16lx (%6ld MB)\n"
#endif
" modules : 0x%16lx - 0x%16lx (%6ld MB)\n"
" memory : 0x%16lx - 0x%16lx (%6ld MB)\n"
" .init : 0x%p" " - 0x%p" " (%6ld kB)\n"
" .text : 0x%p" " - 0x%p" " (%6ld kB)\n"
" .data : 0x%p" " - 0x%p" " (%6ld kB)\n",
MLM(VMALLOC_START, VMALLOC_END),
#ifdef CONFIG_SPARSEMEM_VMEMMAP
MLM((unsigned long)virt_to_page(PAGE_OFFSET),
(unsigned long)virt_to_page(high_memory)),
#endif
MLM(MODULES_VADDR, MODULES_END),
MLM(PAGE_OFFSET, (unsigned long)high_memory),
MLK_ROUNDUP(__init_begin, __init_end),
MLK_ROUNDUP(_text, _etext),
MLK_ROUNDUP(_sdata, _edata));
#undef MLK
#undef MLM
#undef MLK_ROUNDUP
/*
* Check boundaries twice: Some fundamental inconsistencies can be
* detected at build time already.
*/
#ifdef CONFIG_COMPAT
BUILD_BUG_ON(TASK_SIZE_32 > TASK_SIZE_64);
#endif
BUILD_BUG_ON(TASK_SIZE_64 > MODULES_VADDR);
BUG_ON(TASK_SIZE_64 > MODULES_VADDR);
if (PAGE_SIZE >= 16384 && get_num_physpages() <= 128) {
extern int sysctl_overcommit_memory;
/*
* On a machine this small we won't get anywhere without
* overcommit, so turn it on by default.
*/
sysctl_overcommit_memory = OVERCOMMIT_ALWAYS;
}
}
void free_initmem(void)
{
free_initmem_default(0);
}
#ifdef CONFIG_BLK_DEV_INITRD
static int keep_initrd;
void free_initrd_mem(unsigned long start, unsigned long end)
{
if (!keep_initrd)
free_reserved_area((void *)start, (void *)end, 0, "initrd");
}
static int __init keepinitrd_setup(char *__unused)
{
keep_initrd = 1;
return 1;
}
__setup("keepinitrd", keepinitrd_setup);
#endif