![Matej Vasek](/assets/img/avatar_default.png)
The code contained typos like "structur", "fointers", etc. Fix that. No code change, only comments. Signed-off-by: Matej Vasek <xvasek1@fi.muni.cz> Cc: Sudip Mukherjee <sudipm.mukherjee@gmail.com> Cc: Teddy Wang <teddy.wang@siliconmotion.com> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org> Cc: <linux-fbdev@vger.kernel.org> Cc: <devel@driverdev.osuosl.org> Signed-off-by: Jiri Slaby <jslaby@suse.cz> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
175 lines
5.4 KiB
C
175 lines
5.4 KiB
C
#ifndef DDK750_SII164_H__
|
|
#define DDK750_SII164_H__
|
|
|
|
#define USE_DVICHIP
|
|
|
|
/* Hot Plug detection mode structure */
|
|
typedef enum _sii164_hot_plug_mode_t {
|
|
SII164_HOTPLUG_DISABLE = 0, /* Disable Hot Plug output bit (always high). */
|
|
SII164_HOTPLUG_USE_MDI, /* Use Monitor Detect Interrupt bit. */
|
|
SII164_HOTPLUG_USE_RSEN, /* Use Receiver Sense detect bit. */
|
|
SII164_HOTPLUG_USE_HTPLG /* Use Hot Plug detect bit. */
|
|
} sii164_hot_plug_mode_t;
|
|
|
|
|
|
/* Silicon Image SiI164 chip prototype */
|
|
long sii164InitChip(
|
|
unsigned char edgeSelect,
|
|
unsigned char busSelect,
|
|
unsigned char dualEdgeClkSelect,
|
|
unsigned char hsyncEnable,
|
|
unsigned char vsyncEnable,
|
|
unsigned char deskewEnable,
|
|
unsigned char deskewSetting,
|
|
unsigned char continuousSyncEnable,
|
|
unsigned char pllFilterEnable,
|
|
unsigned char pllFilterValue
|
|
);
|
|
|
|
unsigned short sii164GetVendorID(void);
|
|
unsigned short sii164GetDeviceID(void);
|
|
|
|
|
|
#ifdef SII164_FULL_FUNCTIONS
|
|
void sii164ResetChip(void);
|
|
char *sii164GetChipString(void);
|
|
void sii164SetPower(unsigned char powerUp);
|
|
void sii164EnableHotPlugDetection(unsigned char enableHotPlug);
|
|
unsigned char sii164IsConnected(void);
|
|
unsigned char sii164CheckInterrupt(void);
|
|
void sii164ClearInterrupt(void);
|
|
#endif
|
|
/*
|
|
* below register definition is used for
|
|
* Silicon Image SiI164 DVI controller chip
|
|
*/
|
|
/*
|
|
* Vendor ID registers
|
|
*/
|
|
#define SII164_VENDOR_ID_LOW 0x00
|
|
#define SII164_VENDOR_ID_HIGH 0x01
|
|
|
|
/*
|
|
* Device ID registers
|
|
*/
|
|
#define SII164_DEVICE_ID_LOW 0x02
|
|
#define SII164_DEVICE_ID_HIGH 0x03
|
|
|
|
/*
|
|
* Device Revision
|
|
*/
|
|
#define SII164_DEVICE_REVISION 0x04
|
|
|
|
/*
|
|
* Frequency Limitation registers
|
|
*/
|
|
#define SII164_FREQUENCY_LIMIT_LOW 0x06
|
|
#define SII164_FREQUENCY_LIMIT_HIGH 0x07
|
|
|
|
/*
|
|
* Power Down and Input Signal Configuration registers
|
|
*/
|
|
#define SII164_CONFIGURATION 0x08
|
|
|
|
/* Power down (PD) */
|
|
#define SII164_CONFIGURATION_POWER_DOWN 0x00
|
|
#define SII164_CONFIGURATION_POWER_NORMAL 0x01
|
|
#define SII164_CONFIGURATION_POWER_MASK 0x01
|
|
|
|
/* Input Edge Latch Select (EDGE) */
|
|
#define SII164_CONFIGURATION_LATCH_FALLING 0x00
|
|
#define SII164_CONFIGURATION_LATCH_RISING 0x02
|
|
|
|
/* Bus Select (BSEL) */
|
|
#define SII164_CONFIGURATION_BUS_12BITS 0x00
|
|
#define SII164_CONFIGURATION_BUS_24BITS 0x04
|
|
|
|
/* Dual Edge Clock Select (DSEL) */
|
|
#define SII164_CONFIGURATION_CLOCK_SINGLE 0x00
|
|
#define SII164_CONFIGURATION_CLOCK_DUAL 0x08
|
|
|
|
/* Horizontal Sync Enable (HEN) */
|
|
#define SII164_CONFIGURATION_HSYNC_FORCE_LOW 0x00
|
|
#define SII164_CONFIGURATION_HSYNC_AS_IS 0x10
|
|
|
|
/* Vertical Sync Enable (VEN) */
|
|
#define SII164_CONFIGURATION_VSYNC_FORCE_LOW 0x00
|
|
#define SII164_CONFIGURATION_VSYNC_AS_IS 0x20
|
|
|
|
/*
|
|
* Detection registers
|
|
*/
|
|
#define SII164_DETECT 0x09
|
|
|
|
/* Monitor Detect Interrupt (MDI) */
|
|
#define SII164_DETECT_MONITOR_STATE_CHANGE 0x00
|
|
#define SII164_DETECT_MONITOR_STATE_NO_CHANGE 0x01
|
|
#define SII164_DETECT_MONITOR_STATE_CLEAR 0x01
|
|
#define SII164_DETECT_MONITOR_STATE_MASK 0x01
|
|
|
|
/* Hot Plug detect Input (HTPLG) */
|
|
#define SII164_DETECT_HOT_PLUG_STATUS_OFF 0x00
|
|
#define SII164_DETECT_HOT_PLUG_STATUS_ON 0x02
|
|
#define SII164_DETECT_HOT_PLUG_STATUS_MASK 0x02
|
|
|
|
/* Receiver Sense (RSEN) */
|
|
#define SII164_DETECT_RECEIVER_SENSE_NOT_DETECTED 0x00
|
|
#define SII164_DETECT_RECEIVER_SENSE_DETECTED 0x04
|
|
|
|
/* Interrupt Generation Method (TSEL) */
|
|
#define SII164_DETECT_INTERRUPT_BY_RSEN_PIN 0x00
|
|
#define SII164_DETECT_INTERRUPT_BY_HTPLG_PIN 0x08
|
|
#define SII164_DETECT_INTERRUPT_MASK 0x08
|
|
|
|
/* Monitor Sense Output (MSEN) */
|
|
#define SII164_DETECT_MONITOR_SENSE_OUTPUT_HIGH 0x00
|
|
#define SII164_DETECT_MONITOR_SENSE_OUTPUT_MDI 0x10
|
|
#define SII164_DETECT_MONITOR_SENSE_OUTPUT_RSEN 0x20
|
|
#define SII164_DETECT_MONITOR_SENSE_OUTPUT_HTPLG 0x30
|
|
#define SII164_DETECT_MONITOR_SENSE_OUTPUT_FLAG 0x30
|
|
|
|
/*
|
|
* Skewing registers
|
|
*/
|
|
#define SII164_DESKEW 0x0A
|
|
|
|
/* General Purpose Input (CTL[3:1]) */
|
|
#define SII164_DESKEW_GENERAL_PURPOSE_INPUT_MASK 0x0E
|
|
|
|
/* De-skewing Enable bit (DKEN) */
|
|
#define SII164_DESKEW_DISABLE 0x00
|
|
#define SII164_DESKEW_ENABLE 0x10
|
|
|
|
/* De-skewing Setting (DK[3:1])*/
|
|
#define SII164_DESKEW_1_STEP 0x00
|
|
#define SII164_DESKEW_2_STEP 0x20
|
|
#define SII164_DESKEW_3_STEP 0x40
|
|
#define SII164_DESKEW_4_STEP 0x60
|
|
#define SII164_DESKEW_5_STEP 0x80
|
|
#define SII164_DESKEW_6_STEP 0xA0
|
|
#define SII164_DESKEW_7_STEP 0xC0
|
|
#define SII164_DESKEW_8_STEP 0xE0
|
|
|
|
/*
|
|
* User Configuration Data registers (CFG 7:0)
|
|
*/
|
|
#define SII164_USER_CONFIGURATION 0x0B
|
|
|
|
/*
|
|
* PLL registers
|
|
*/
|
|
#define SII164_PLL 0x0C
|
|
|
|
/* PLL Filter Value (PLLF) */
|
|
#define SII164_PLL_FILTER_VALUE_MASK 0x0E
|
|
|
|
/* PLL Filter Enable (PFEN) */
|
|
#define SII164_PLL_FILTER_DISABLE 0x00
|
|
#define SII164_PLL_FILTER_ENABLE 0x01
|
|
|
|
/* Sync Continuous (SCNT) */
|
|
#define SII164_PLL_FILTER_SYNC_CONTINUOUS_DISABLE 0x00
|
|
#define SII164_PLL_FILTER_SYNC_CONTINUOUS_ENABLE 0x80
|
|
|
|
#endif
|