redonkable/alistair23-linux
redonkable/alistair23-linux
1
0
Fork 0
Code Releases Activity
alistair23-linux/arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi
Jon Hunter 2fdb74fe4e arm64: tegra: Add CPU and PSCI nodes for NVIDIA Tegra210 platforms 
Add the CPU and PSCI nodes for the NVIDIA Tegra210 platforms so that
all CPUs can be enabled on boot. This assumes that the PSCI firmware
has been loaded during the initial bootstrap on the device before the
kernel starts (which is typically the case for these platforms). The
PSCI firmware version is set to v0.2 which aligns with the current
shipping version for Tegra.

Reported-by: Martin Michlmayr <tbm@cyrius.com>
Signed-off-by: Jon Hunter <jonathanh@nvidia.com>
Tested-By: Vagrant Cascadian <vagrant@debian.org>
Signed-off-by: Thierry Reding <treding@nvidia.com>
2017-12-13 14:44:46 +01:00

337 lines
7.2 KiB
Plaintext
Raw Blame History

// SPDX-License-Identifier: GPL-2.0
#include <dt-bindings/mfd/max77620.h>
#include "tegra210.dtsi"
/ {
model = "NVIDIA Jetson TX1";
compatible = "nvidia,p2180", "nvidia,tegra210";
aliases {
rtc0 = "/i2c@7000d000/pmic@3c";
rtc1 = "/rtc@7000e000";
serial0 = &uarta;
};
chosen {
stdout-path = "serial0:115200n8";
};
memory {
device_type = "memory";
reg = <0x0 0x80000000 0x1 0x0>;
};
gpu@57000000 {
vdd-supply = <&vdd_gpu>;
};
/* debug port */
serial@70006000 {
status = "okay";
};
i2c@7000d000 {
status = "okay";
clock-frequency = <400000>;
pmic: pmic@3c {
compatible = "maxim,max77620";
reg = <0x3c>;
interrupts = <GIC_SPI 86 IRQ_TYPE_LEVEL_HIGH>;
#interrupt-cells = <2>;
interrupt-controller;
#gpio-cells = <2>;
gpio-controller;
pinctrl-names = "default";
pinctrl-0 = <&max77620_default>;
max77620_default: pinmux {
gpio0 {
pins = "gpio0";
function = "gpio";
};
gpio1 {
pins = "gpio1";
function = "fps-out";
drive-push-pull = <1>;
maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
maxim,active-fps-power-up-slot = <7>;
maxim,active-fps-power-down-slot = <0>;
};
gpio2_3 {
pins = "gpio2", "gpio3";
function = "fps-out";
drive-open-drain = <1>;
maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
};
gpio4 {
pins = "gpio4";
function = "32k-out1";
};
gpio5_6_7 {
pins = "gpio5", "gpio6", "gpio7";
function = "gpio";
drive-push-pull = <1>;
};
};
fps {
fps0 {
maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_EN0>;
maxim,suspend-fps-time-period-us = <1280>;
};
fps1 {
maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_EN1>;
maxim,suspend-fps-time-period-us = <1280>;
};
fps2 {
maxim,fps-event-source = <MAX77620_FPS_EVENT_SRC_EN0>;
};
};
regulators {
in-ldo0-1-supply = <&vdd_pre>;
in-ldo7-8-supply = <&vdd_pre>;
in-sd3-supply = <&vdd_5v0_sys>;
vdd_soc: sd0 {
regulator-name = "VDD_SOC";
regulator-min-microvolt = <600000>;
regulator-max-microvolt = <1400000>;
regulator-always-on;
regulator-boot-on;
regulator-enable-ramp-delay = <146>;
regulator-ramp-delay = <27500>;
maxim,active-fps-source = <MAX77620_FPS_SRC_1>;
};
vdd_ddr: sd1 {
regulator-name = "VDD_DDR_1V1_PMIC";
regulator-always-on;
regulator-boot-on;
regulator-enable-ramp-delay = <130>;
regulator-ramp-delay = <27500>;
maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
};
vdd_pre: sd2 {
regulator-name = "VDD_PRE_REG_1V35";
regulator-min-microvolt = <1350000>;
regulator-max-microvolt = <1350000>;
regulator-enable-ramp-delay = <176>;
regulator-ramp-delay = <27500>;
maxim,active-fps-source = <MAX77620_FPS_SRC_1>;
};
vdd_1v8: sd3 {
regulator-name = "VDD_1V8";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
regulator-always-on;
regulator-boot-on;
regulator-enable-ramp-delay = <242>;
regulator-ramp-delay = <27500>;
maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
};
vdd_sys_1v2: ldo0 {
regulator-name = "AVDD_SYS_1V2";
regulator-min-microvolt = <1200000>;
regulator-max-microvolt = <1200000>;
regulator-always-on;
regulator-boot-on;
regulator-enable-ramp-delay = <26>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_NONE>;
};
vdd_pex_1v05: ldo1 {
regulator-name = "VDD_PEX_1V05";
regulator-min-microvolt = <1050000>;
regulator-max-microvolt = <1050000>;
regulator-enable-ramp-delay = <22>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_1>;
};
vddio_sdmmc: ldo2 {
regulator-name = "VDDIO_SDMMC";
/*
* Technically this supply should have
* a supported range from 1.8 - 3.3 V.
* However, that would cause the SDHCI
* driver to request 2.7 V upon access
* and that in turn will cause traffic
* to be broken. Leave it at 3.3 V for
* now.
*/
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-always-on;
regulator-boot-on;
regulator-enable-ramp-delay = <62>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_NONE>;
};
vdd_cam_hv: ldo3 {
regulator-name = "VDD_CAM_HV";
regulator-min-microvolt = <2800000>;
regulator-max-microvolt = <2800000>;
regulator-enable-ramp-delay = <50>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_NONE>;
};
vdd_rtc: ldo4 {
regulator-name = "VDD_RTC";
regulator-min-microvolt = <850000>;
regulator-max-microvolt = <850000>;
regulator-always-on;
regulator-boot-on;
regulator-enable-ramp-delay = <22>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
};
vdd_ts_hv: ldo5 {
regulator-name = "VDD_TS_HV";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-enable-ramp-delay = <62>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_NONE>;
};
vdd_ts: ldo6 {
regulator-name = "VDD_TS_1V8";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
regulator-enable-ramp-delay = <36>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
maxim,active-fps-power-up-slot = <7>;
maxim,active-fps-power-down-slot = <0>;
};
avdd_1v05_pll: ldo7 {
regulator-name = "AVDD_1V05_PLL";
regulator-min-microvolt = <1050000>;
regulator-max-microvolt = <1050000>;
regulator-always-on;
regulator-boot-on;
regulator-enable-ramp-delay = <24>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_1>;
};
avdd_1v05: ldo8 {
regulator-name = "AVDD_SATA_HDMI_DP_1V05";
regulator-min-microvolt = <1050000>;
regulator-max-microvolt = <1050000>;
regulator-enable-ramp-delay = <22>;
regulator-ramp-delay = <100000>;
maxim,active-fps-source = <MAX77620_FPS_SRC_1>;
};
};
};
};
pmc@7000e400 {
nvidia,invert-interrupt;
};
/* eMMC */
sdhci@700b0600 {
status = "okay";
bus-width = <8>;
non-removable;
};
clocks {
compatible = "simple-bus";
#address-cells = <1>;
#size-cells = <0>;
clk32k_in: clock@0 {
compatible = "fixed-clock";
reg = <0>;
#clock-cells = <0>;
clock-frequency = <32768>;
};
};
cpus {
cpu@0 {
enable-method = "psci";
};
cpu@1 {
enable-method = "psci";
};
cpu@2 {
enable-method = "psci";
};
cpu@3 {
enable-method = "psci";
};
};
psci {
compatible = "arm,psci-0.2";
method = "smc";
};
regulators {
vdd_gpu: regulator@100 {
compatible = "pwm-regulator";
reg = <100>;
pwms = <&pwm 1 4880>;
regulator-name = "VDD_GPU";
regulator-min-microvolt = <710000>;
regulator-max-microvolt = <1320000>;
enable-gpios = <&pmic 6 GPIO_ACTIVE_HIGH>;
regulator-ramp-delay = <80>;
regulator-enable-ramp-delay = <1000>;
};
};
};
View git blame Copy permalink