![Joe Millenbach](/assets/img/avatar_default.png)
The option allows you to remove TTY and compile without errors. This saves space on systems that won't support TTY interfaces anyway. bloat-o-meter output is below. The bulk of this patch consists of Kconfig changes adding "depends on TTY" to various serial devices and similar drivers that require the TTY layer. Ideally, these dependencies would occur on a common intermediate symbol such as SERIO, but most drivers "select SERIO" rather than "depends on SERIO", and "select" does not respect dependencies. bloat-o-meter output comparing our previous minimal to new minimal by removing TTY. The list is filtered to not show removed entries with awk '$3 != "-"' as the list was very long. add/remove: 0/226 grow/shrink: 2/14 up/down: 6/-35356 (-35350) function old new delta chr_dev_init 166 170 +4 allow_signal 80 82 +2 static.__warned 143 142 -1 disallow_signal 63 62 -1 __set_special_pids 95 94 -1 unregister_console 126 121 -5 start_kernel 546 541 -5 register_console 593 588 -5 copy_from_user 45 40 -5 sys_setsid 128 120 -8 sys_vhangup 32 19 -13 do_exit 1543 1526 -17 bitmap_zero 60 40 -20 arch_local_irq_save 137 117 -20 release_task 674 652 -22 static.spin_unlock_irqrestore 308 260 -48 Signed-off-by: Joe Millenbach <jmillenbach@gmail.com> Reviewed-by: Jamey Sharp <jamey@minilop.net> Reviewed-by: Josh Triplett <josh@joshtriplett.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
26 lines
1.4 KiB
Plaintext
26 lines
1.4 KiB
Plaintext
if USB_GADGET
|
|
|
|
config USB_G_CCG
|
|
tristate "Configurable Composite Gadget (STAGING)"
|
|
depends on STAGING && BLOCK && NET && !USB_ZERO && !USB_ZERO_HNPTEST && !USB_AUDIO && !GADGET_UAC1 && !USB_ETH && !USB_ETH_RNDIS && !USB_ETH_EEM && !USB_G_NCM && !USB_GADGETFS && !USB_FUNCTIONFS && !USB_FUNCTIONFS_ETH && !USB_FUNCTIONFS_RNDIS && !USB_FUNCTIONFS_GENERIC && !USB_FILE_STORAGE && !USB_FILE_STORAGE_TEST && !USB_MASS_STORAGE && !USB_G_SERIAL && !USB_MIDI_GADGET && !USB_G_PRINTER && !USB_CDC_COMPOSITE && !USB_G_NOKIA && !USB_G_ACM_MS && !USB_G_MULTI && !USB_G_MULTI_RNDIS && !USB_G_MULTI_CDC && !USB_G_HID && !USB_G_DBGP && !USB_G_WEBCAM && TTY
|
|
help
|
|
The Configurable Composite Gadget supports multiple USB
|
|
functions: acm, mass storage, rndis and FunctionFS.
|
|
Each function can be configured and enabled/disabled
|
|
dynamically from userspace through a sysfs interface.
|
|
|
|
In order to compile this (either as a module or built-in),
|
|
"USB Gadget Drivers" and anything under it must not be
|
|
selected compiled-in in
|
|
Device Drivers->USB Support->USB Gadget Support.
|
|
However, you can say "M" there, if you do, the
|
|
Configurable Composite Gadget can be compiled "M" only
|
|
or not at all.
|
|
|
|
BIG FAT NOTE: DON'T RELY ON THIS USERINTERFACE HERE! AS PART
|
|
OF THE REWORK DONE HERE WILL BE A NEW USER INTERFACE WITHOUT ANY
|
|
COMPATIBILITY TO THIS SYSFS INTERFACE HERE. BE AWARE OF THIS
|
|
BEFORE SELECTING THIS.
|
|
|
|
endif # USB_GADGET
|