ddba7c5ad7
Remove the compile-time option for FAST_READ, since we have run-time support for detecting it. This refactors the logic for enabling fast-read, such that for DT-enabled devices, we honor the "m25p,fast-read" property but for non-DT devices, we default to using FAST_READ whenever the flash device supports it. Normal READ and FAST_READ differ only in the following: * FAST_READ supports SPI higher clock frequencies [1] * number of dummy cycles; FAST_READ requires 8 dummy cycles (whereas READ requires 0) to allow the flash sufficient setup time, even when running at higher clock speeds Thus, for flash chips which support FAST_READ, there is otherwise no limiting reason why we cannot use the FAST_READ opcode instead of READ. It simply allows the SPI controller to run at higher clock rates. So theoretically, nobody should be needing the compile-time option anyway. [1] I have a Spansion S25FL128S datasheet which says: "The maximum operating clock frequency for the READ command is 50 MHz." And: "The maximum operating clock frequency for FAST READ command is 133 MHz." Signed-off-by: Brian Norris <computersforpeace@gmail.com> |
||
---|---|---|
.. | ||
chips | ||
devices | ||
lpddr | ||
maps | ||
nand | ||
onenand | ||
tests | ||
ubi | ||
afs.c | ||
ar7part.c | ||
bcm47xxpart.c | ||
bcm63xxpart.c | ||
cmdlinepart.c | ||
ftl.c | ||
inftlcore.c | ||
inftlmount.c | ||
Kconfig | ||
Makefile | ||
mtd_blkdevs.c | ||
mtdblock.c | ||
mtdblock_ro.c | ||
mtdchar.c | ||
mtdconcat.c | ||
mtdcore.c | ||
mtdcore.h | ||
mtdoops.c | ||
mtdpart.c | ||
mtdsuper.c | ||
mtdswap.c | ||
nftlcore.c | ||
nftlmount.c | ||
ofpart.c | ||
redboot.c | ||
rfd_ftl.c | ||
sm_ftl.c | ||
sm_ftl.h | ||
ssfdc.c |