1004a2977b
Use the new EBI/NAND bindings to declare NAND chips and remove old NAND nodes along the way. Note that we keep using old bindings in at91rm9200.dtsi because this SoC is not supported by the EBI driver. Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com> Tested-by: Peter Rosin <peda@axentia.se> Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
67 lines
1.2 KiB
Plaintext
67 lines
1.2 KiB
Plaintext
/*
|
|
* ge863_pro3.dtsi - Device Tree file for Telit GE863-PRO3
|
|
*
|
|
* Copyright (C) 2012 Telit,
|
|
* 2012 Fabio Porcedda <fabio.porcedda@gmail.com>
|
|
*
|
|
* Licensed under GPLv2 or later.
|
|
*/
|
|
|
|
#include "at91sam9260.dtsi"
|
|
|
|
/ {
|
|
clocks {
|
|
main_xtal {
|
|
clock-frequency = <6000000>;
|
|
};
|
|
};
|
|
|
|
ahb {
|
|
apb {
|
|
dbgu: serial@fffff200 {
|
|
status = "okay";
|
|
};
|
|
};
|
|
|
|
ebi: ebi@10000000 {
|
|
status = "okay";
|
|
|
|
nand_controller: nand-controller {
|
|
status = "okay";
|
|
pinctrl-0 = <&pinctrl_nand_cs &pinctrl_nand_rb>;
|
|
pinctrl-names = "default";
|
|
|
|
nand@3 {
|
|
reg = <0x3 0x0 0x800000>;
|
|
rb-gpios = <&pioC 13 GPIO_ACTIVE_HIGH>;
|
|
cs-gpios = <&pioC 14 GPIO_ACTIVE_HIGH>;
|
|
nand-bus-width = <8>;
|
|
nand-ecc-mode = "soft";
|
|
nand-on-flash-bbt;
|
|
label = "atmel_nand";
|
|
|
|
partitions {
|
|
compatible = "fixed-partitions";
|
|
#address-cells = <1>;
|
|
#size-cells = <1>;
|
|
|
|
boot@0 {
|
|
label = "boot";
|
|
reg = <0x0 0x7c0000>;
|
|
};
|
|
|
|
root@07c0000 {
|
|
label = "root";
|
|
reg = <0x7c0000 0x7840000>;
|
|
};
|
|
};
|
|
};
|
|
};
|
|
};
|
|
};
|
|
|
|
chosen {
|
|
bootargs = "console=ttyS0,115200 root=ubi0:rootfs ubi.mtd=1 rootfstype=ubifs";
|
|
};
|
|
};
|