alistair23-linux/arch/arm/boot/dts/qcom-ipq4019-ap.dk01.1.dtsi
Christian Lamparter 0d363594c5 ARM: dts: qcom: add and enable both wifi blocks on the IPQ4019
This patch adds and enables the device-tree definitions for
both qcom,ipq4019-wifi blocks for the IPQ4019.

Support for these have been added into the ath10k driver since:
commit 280e762e9c ("ath10k: enable ipq4019 device probe in ahb module")

The binding documentation was added in:
commit a47aaa69de ("dt: bindings: add new dt entry for pre calibration in qcom, ath10k.txt")

This has been tested on an ASUS RT-AC58U (IPQ4019),
an AVM Fritz!Box 4040 (IPQ4018), a Compex WPJ428 (IPQ4028)
and a Cisco Meraki MR33 (IPQ4029).

| a000000.wifi: qca4019 hw1.0 target 0x01000000 chip_id 0x003b00ff [...]
| a000000.wifi: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
| a000000.wifi: firmware ver 10.4-3.4-00082 api 5 features no-p2p,mfp,[...]
| a000000.wifi: board_file api 2 bmi_id 0:16 crc32 5773b188
| a000000.wifi: htt-ver 2.2 wmi-op 6 htt-op 4 cal pre-cal-file [...]
...
| a800000.wifi: qca4019 hw1.0 target 0x01000000 chip_id 0x003b00ff sub 0000:0000
| a800000.wifi: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
| a800000.wifi: firmware ver 10.4-3.4-00082 api 5 features no-p2p, [...]
| a800000.wifi: board_file api 2 bmi_id 0:17 crc32 5773b188
| a800000.wifi: htt-ver 2.2 wmi-op 6 htt-op 4 cal pre-cal-file [...]

Signed-off-by: Christian Lamparter <chunkeey@googlemail.com>
Signed-off-by: Andy Gross <andy.gross@linaro.org>
2017-08-08 14:53:12 -05:00

106 lines
2.2 KiB
Plaintext

/* Copyright (c) 2015, The Linux Foundation. All rights reserved.
*
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
* copyright notice and this permission notice appear in all copies.
*
* THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
* WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
* ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
* WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
* ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
* OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
*
*/
#include "qcom-ipq4019.dtsi"
/ {
model = "Qualcomm Technologies, Inc. IPQ4019/AP-DK01.1";
compatible = "qcom,ipq4019";
soc {
rng@22000 {
status = "ok";
};
pinctrl@1000000 {
serial_pins: serial_pinmux {
mux {
pins = "gpio60", "gpio61";
function = "blsp_uart0";
bias-disable;
};
};
spi_0_pins: spi_0_pinmux {
pinmux {
function = "blsp_spi0";
pins = "gpio55", "gpio56", "gpio57";
};
pinmux_cs {
function = "gpio";
pins = "gpio54";
};
pinconf {
pins = "gpio55", "gpio56", "gpio57";
drive-strength = <12>;
bias-disable;
};
pinconf_cs {
pins = "gpio54";
drive-strength = <2>;
bias-disable;
output-high;
};
};
};
blsp_dma: dma@7884000 {
status = "ok";
};
spi_0: spi@78b5000 {
pinctrl-0 = <&spi_0_pins>;
pinctrl-names = "default";
status = "ok";
cs-gpios = <&tlmm 54 0>;
mx25l25635e@0 {
#address-cells = <1>;
#size-cells = <1>;
reg = <0>;
compatible = "mx25l25635e";
spi-max-frequency = <24000000>;
};
};
serial@78af000 {
pinctrl-0 = <&serial_pins>;
pinctrl-names = "default";
status = "ok";
};
cryptobam: dma@8e04000 {
status = "ok";
};
crypto@8e3a000 {
status = "ok";
};
watchdog@b017000 {
status = "ok";
};
wifi@a000000 {
status = "ok";
};
wifi@a800000 {
status = "ok";
};
};
};