diff --git a/README.md b/README.md index 5a2013f..6eede64 100644 --- a/README.md +++ b/README.md @@ -22,7 +22,7 @@ To put the rM2 in recovery, you will need: * run `dmesg -w` on your host to monitor * power off the device * connect the USB-C breakout board -* pull down **B8** (connect a 10K resistor to GND) +* pull down **B8** (connect B8 over a 10K resistor to B1) * connect the pogo pins to the tablet and to the host usb * **make sure the connection is good, use a short good, different cable, etc** * if the device does not start on its own, press the Power Button @@ -32,7 +32,3 @@ To put the rM2 in recovery, you will need: * should see *USB Mass Storage device detected* * should see a new mountable block device -## Notes - -- B8 has to be connected to the same ground as the Pogo GND pin -- The ID pin on Pogo connector is not connected to anything