[TG3]: add 5780 basic jumbo frame support
Add basic jumbo frames support for 5780. This chip supports jumbo frames on the standard receive ring without the jumbo ring. The TG3_FLAG_JUMBO_ENABLE is changed to TG3_FLAG_JUMBO_RING_ENABLE to indicate using the jumbo ring on 5704 and older chips. A new TG3_FLG2_JUMBO_CAPABLE flag is added to indicate jumbo frames support with or without the jumbo ring. Signed-off-by: Michael Chan <mchan@broadcom.com> Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
parent
4cf78e4fb6
commit
0f893dc6ec
|
@ -90,7 +90,7 @@
|
|||
/* hardware minimum and maximum for a single frame's data payload */
|
||||
#define TG3_MIN_MTU 60
|
||||
#define TG3_MAX_MTU(tp) \
|
||||
(!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS) ? 9000 : 1500)
|
||||
((tp->tg3_flags2 & TG3_FLG2_JUMBO_CAPABLE) ? 9000 : 1500)
|
||||
|
||||
/* These numbers seem to be hard coded in the NIC firmware somehow.
|
||||
* You can't change the ring sizes, but you can change where you place
|
||||
|
@ -914,7 +914,7 @@ out:
|
|||
if ((tp->phy_id & PHY_ID_MASK) == PHY_ID_BCM5401) {
|
||||
/* Cannot do read-modify-write on 5401 */
|
||||
tg3_writephy(tp, MII_TG3_AUX_CTRL, 0x4c20);
|
||||
} else if (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS)) {
|
||||
} else if (tp->tg3_flags2 & TG3_FLG2_JUMBO_CAPABLE) {
|
||||
u32 phy_reg;
|
||||
|
||||
/* Set bit 14 with read-modify-write to preserve other bits */
|
||||
|
@ -926,7 +926,7 @@ out:
|
|||
/* Set phy register 0x10 bit 0 to high fifo elasticity to support
|
||||
* jumbo frames transmission.
|
||||
*/
|
||||
if (!(tp->tg3_flags2 & TG3_FLG2_5705_PLUS)) {
|
||||
if (tp->tg3_flags2 & TG3_FLG2_JUMBO_CAPABLE) {
|
||||
u32 phy_reg;
|
||||
|
||||
if (!tg3_readphy(tp, MII_TG3_EXT_CTRL, &phy_reg))
|
||||
|
@ -3444,9 +3444,9 @@ static inline void tg3_set_mtu(struct net_device *dev, struct tg3 *tp,
|
|||
dev->mtu = new_mtu;
|
||||
|
||||
if (new_mtu > ETH_DATA_LEN)
|
||||
tp->tg3_flags |= TG3_FLAG_JUMBO_ENABLE;
|
||||
tp->tg3_flags |= TG3_FLAG_JUMBO_RING_ENABLE;
|
||||
else
|
||||
tp->tg3_flags &= ~TG3_FLAG_JUMBO_ENABLE;
|
||||
tp->tg3_flags &= ~TG3_FLAG_JUMBO_RING_ENABLE;
|
||||
}
|
||||
|
||||
static int tg3_change_mtu(struct net_device *dev, int new_mtu)
|
||||
|
@ -3588,7 +3588,7 @@ static void tg3_init_rings(struct tg3 *tp)
|
|||
(i << RXD_OPAQUE_INDEX_SHIFT));
|
||||
}
|
||||
|
||||
if (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) {
|
||||
if (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) {
|
||||
for (i = 0; i < TG3_RX_JUMBO_RING_SIZE; i++) {
|
||||
struct tg3_rx_buffer_desc *rxd;
|
||||
|
||||
|
@ -3609,7 +3609,7 @@ static void tg3_init_rings(struct tg3 *tp)
|
|||
break;
|
||||
}
|
||||
|
||||
if (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) {
|
||||
if (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) {
|
||||
for (i = 0; i < tp->rx_jumbo_pending; i++) {
|
||||
if (tg3_alloc_rx_skb(tp, RXD_OPAQUE_RING_JUMBO,
|
||||
-1, i) < 0)
|
||||
|
@ -5277,7 +5277,7 @@ static int tg3_reset_hw(struct tg3 *tp)
|
|||
}
|
||||
#endif
|
||||
|
||||
if (!(tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE)) {
|
||||
if (tp->dev->mtu <= ETH_DATA_LEN) {
|
||||
tw32(BUFMGR_MB_RDMA_LOW_WATER,
|
||||
tp->bufmgr_config.mbuf_read_dma_low_water);
|
||||
tw32(BUFMGR_MB_MACRX_LOW_WATER,
|
||||
|
@ -5352,7 +5352,7 @@ static int tg3_reset_hw(struct tg3 *tp)
|
|||
/* Setup replenish threshold. */
|
||||
tw32(RCVBDI_JUMBO_THRESH, tp->rx_jumbo_pending / 8);
|
||||
|
||||
if (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) {
|
||||
if (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) {
|
||||
tw32(RCVDBDI_JUMBO_BD + TG3_BDINFO_HOST_ADDR + TG3_64BIT_REG_HIGH,
|
||||
((u64) tp->rx_jumbo_mapping >> 32));
|
||||
tw32(RCVDBDI_JUMBO_BD + TG3_BDINFO_HOST_ADDR + TG3_64BIT_REG_LOW,
|
||||
|
@ -5413,7 +5413,7 @@ static int tg3_reset_hw(struct tg3 *tp)
|
|||
tw32_rx_mbox(MAILBOX_RCV_STD_PROD_IDX + TG3_64BIT_REG_LOW,
|
||||
tp->rx_std_ptr);
|
||||
|
||||
tp->rx_jumbo_ptr = (tp->tg3_flags & TG3_FLAG_JUMBO_ENABLE) ?
|
||||
tp->rx_jumbo_ptr = (tp->tg3_flags & TG3_FLAG_JUMBO_RING_ENABLE) ?
|
||||
tp->rx_jumbo_pending : 0;
|
||||
tw32_rx_mbox(MAILBOX_RCV_JUMBO_PROD_IDX + TG3_64BIT_REG_LOW,
|
||||
tp->rx_jumbo_ptr);
|
||||
|
@ -8991,6 +8991,11 @@ static int __devinit tg3_get_invariants(struct tg3 *tp)
|
|||
if (tp->tg3_flags2 & TG3_FLG2_5750_PLUS)
|
||||
tp->tg3_flags2 |= TG3_FLG2_HW_TSO;
|
||||
|
||||
if (GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5705 &&
|
||||
GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5750 &&
|
||||
GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5752)
|
||||
tp->tg3_flags2 |= TG3_FLG2_JUMBO_CAPABLE;
|
||||
|
||||
if (pci_find_capability(tp->pdev, PCI_CAP_ID_EXP) != 0)
|
||||
tp->tg3_flags2 |= TG3_FLG2_PCI_EXPRESS;
|
||||
|
||||
|
@ -9117,8 +9122,9 @@ static int __devinit tg3_get_invariants(struct tg3 *tp)
|
|||
/* Derive initial jumbo mode from MTU assigned in
|
||||
* ether_setup() via the alloc_etherdev() call
|
||||
*/
|
||||
if (tp->dev->mtu > ETH_DATA_LEN)
|
||||
tp->tg3_flags |= TG3_FLAG_JUMBO_ENABLE;
|
||||
if (tp->dev->mtu > ETH_DATA_LEN &&
|
||||
GET_ASIC_REV(tp->pci_chip_rev_id) != ASIC_REV_5780)
|
||||
tp->tg3_flags |= TG3_FLAG_JUMBO_RING_ENABLE;
|
||||
|
||||
/* Determine WakeOnLan speed to use. */
|
||||
if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5700 ||
|
||||
|
|
|
@ -2125,7 +2125,7 @@ struct tg3 {
|
|||
#define TG3_FLAG_NO_TX_PSEUDO_CSUM 0x00100000
|
||||
#define TG3_FLAG_NO_RX_PSEUDO_CSUM 0x00200000
|
||||
#define TG3_FLAG_SERDES_WOL_CAP 0x00400000
|
||||
#define TG3_FLAG_JUMBO_ENABLE 0x00800000
|
||||
#define TG3_FLAG_JUMBO_RING_ENABLE 0x00800000
|
||||
#define TG3_FLAG_10_100_ONLY 0x01000000
|
||||
#define TG3_FLAG_PAUSE_AUTONEG 0x02000000
|
||||
#define TG3_FLAG_BROKEN_CHECKSUMS 0x10000000
|
||||
|
@ -2155,6 +2155,7 @@ struct tg3 {
|
|||
#define TG3_FLG2_5750_PLUS 0x00080000
|
||||
#define TG3_FLG2_PROTECTED_NVRAM 0x00100000
|
||||
#define TG3_FLG2_USING_MSI 0x00200000
|
||||
#define TG3_FLG2_JUMBO_CAPABLE 0x00400000
|
||||
|
||||
u32 split_mode_max_reqs;
|
||||
#define SPLIT_MODE_5704_MAX_REQ 3
|
||||
|
|
Loading…
Reference in a new issue