thermal: intel_pch_thermal: Read large temp values correctly
On all supported platforms, the TS Reading (TSR) field in the Temperature (TEMP) register is 9 bits wide. Values above 0x100 (78 degrees C) are plausible, so don't mask out the topmost bit. And the register itself is 16 bits wide, so use readw() rather than readl(). Signed-off-by: Ed Swierk <eswierk@skyportsystems.com> Reviewed-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com> Signed-off-by: Zhang Rui <rui.zhang@intel.com>
This commit is contained in:
parent
a742fc10bd
commit
23c973f590
|
@ -49,7 +49,7 @@
|
||||||
#define WPT_TSGPEN 0x84 /* General Purpose Event Enables */
|
#define WPT_TSGPEN 0x84 /* General Purpose Event Enables */
|
||||||
|
|
||||||
/* Wildcat Point-LP PCH Thermal Register bit definitions */
|
/* Wildcat Point-LP PCH Thermal Register bit definitions */
|
||||||
#define WPT_TEMP_TSR 0x00ff /* Temp TS Reading */
|
#define WPT_TEMP_TSR 0x01ff /* Temp TS Reading */
|
||||||
#define WPT_TSC_CPDE 0x01 /* Catastrophic Power-Down Enable */
|
#define WPT_TSC_CPDE 0x01 /* Catastrophic Power-Down Enable */
|
||||||
#define WPT_TSS_TSDSS 0x10 /* Thermal Sensor Dynamic Shutdown Status */
|
#define WPT_TSS_TSDSS 0x10 /* Thermal Sensor Dynamic Shutdown Status */
|
||||||
#define WPT_TSS_GPES 0x08 /* GPE status */
|
#define WPT_TSS_GPES 0x08 /* GPE status */
|
||||||
|
@ -174,9 +174,9 @@ read_trips:
|
||||||
|
|
||||||
static int pch_wpt_get_temp(struct pch_thermal_device *ptd, int *temp)
|
static int pch_wpt_get_temp(struct pch_thermal_device *ptd, int *temp)
|
||||||
{
|
{
|
||||||
u8 wpt_temp;
|
u16 wpt_temp;
|
||||||
|
|
||||||
wpt_temp = WPT_TEMP_TSR & readl(ptd->hw_base + WPT_TEMP);
|
wpt_temp = WPT_TEMP_TSR & readw(ptd->hw_base + WPT_TEMP);
|
||||||
|
|
||||||
/* Resolution of 1/2 degree C and an offset of -50C */
|
/* Resolution of 1/2 degree C and an offset of -50C */
|
||||||
*temp = (wpt_temp * 1000 / 2 - 50000);
|
*temp = (wpt_temp * 1000 / 2 - 50000);
|
||||||
|
|
Loading…
Reference in a new issue