Revert "serial: sccnxp: Add DT support"
This reverts commit 85c9969074
.
Alexander wishes to remove this patch as it is incorrect.
Reported-by: Alexander Shiyan <shc_work@mail.ru>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
This commit is contained in:
parent
3ba35baa55
commit
461a8ecb2d
|
@ -1,53 +0,0 @@
|
||||||
* NXP (Philips) SCC+++(SCN+++) serial driver
|
|
||||||
|
|
||||||
Required properties:
|
|
||||||
- compatible: Should be "nxp,<ictype>". The supported ICs include sc2681,
|
|
||||||
sc2691, sc2692, sc2891, sc2892, sc28202, sc68681 and sc68692.
|
|
||||||
- reg: Address and length of the register set for the device.
|
|
||||||
- interrupts: Should contain the interrupt number. If omitted,
|
|
||||||
polling mode will be used instead, so "poll-interval" property should
|
|
||||||
be populated in this case.
|
|
||||||
|
|
||||||
Optional properties:
|
|
||||||
- clocks: Phandle to input clock. If omitted, default IC frequency will be
|
|
||||||
used instead.
|
|
||||||
- poll-interval: Poll interval time in nanoseconds.
|
|
||||||
- vcc-supply: The regulator supplying the VCC to drive the chip.
|
|
||||||
- nxp,sccnxp-io-cfg: Array contains values for the emulated modem signals.
|
|
||||||
The number of values depends on the UART-number in the selected chip.
|
|
||||||
Each value should be composed according to the following rules:
|
|
||||||
(LINE1 << SIGNAL1) | ... | (LINEX << SIGNALX), where:
|
|
||||||
LINE - VALUE:
|
|
||||||
OP0 - 1
|
|
||||||
OP1 - 2
|
|
||||||
OP2 - 3
|
|
||||||
OP3 - 4
|
|
||||||
OP4 - 5
|
|
||||||
OP5 - 6
|
|
||||||
OP6 - 7
|
|
||||||
OP7 - 8
|
|
||||||
IP0 - 9
|
|
||||||
IP1 - 10
|
|
||||||
IP2 - 11
|
|
||||||
IP3 - 12
|
|
||||||
IP4 - 13
|
|
||||||
IP5 - 14
|
|
||||||
IP6 - 15
|
|
||||||
SIGNAL - VALUE:
|
|
||||||
DTR - 0
|
|
||||||
RTS - 4
|
|
||||||
DSR - 8
|
|
||||||
CTS - 12
|
|
||||||
DCD - 16
|
|
||||||
RNG - 20
|
|
||||||
DIR - 24
|
|
||||||
|
|
||||||
Example (Dual UART with direction control on OP0 & OP1):
|
|
||||||
sc2892@10100000 {
|
|
||||||
compatible = "nxp,sc2892";
|
|
||||||
reg = <0x10100000 0x10>;
|
|
||||||
poll-interval = <10000>;
|
|
||||||
clocks = <&sc2892_clk>;
|
|
||||||
vcc-supply = <&sc2892_reg>;
|
|
||||||
nxp,sccnxp-io-cfg = <0x01000000 0x02000000>;
|
|
||||||
};
|
|
|
@ -20,8 +20,6 @@
|
||||||
#include <linux/module.h>
|
#include <linux/module.h>
|
||||||
#include <linux/device.h>
|
#include <linux/device.h>
|
||||||
#include <linux/console.h>
|
#include <linux/console.h>
|
||||||
#include <linux/of.h>
|
|
||||||
#include <linux/of_device.h>
|
|
||||||
#include <linux/serial_core.h>
|
#include <linux/serial_core.h>
|
||||||
#include <linux/serial.h>
|
#include <linux/serial.h>
|
||||||
#include <linux/io.h>
|
#include <linux/io.h>
|
||||||
|
@ -855,25 +853,10 @@ static const struct platform_device_id sccnxp_id_table[] = {
|
||||||
};
|
};
|
||||||
MODULE_DEVICE_TABLE(platform, sccnxp_id_table);
|
MODULE_DEVICE_TABLE(platform, sccnxp_id_table);
|
||||||
|
|
||||||
static const struct of_device_id sccnxp_dt_id_table[] = {
|
|
||||||
{ .compatible = "nxp,sc2681", .data = &sc2681, },
|
|
||||||
{ .compatible = "nxp,sc2691", .data = &sc2691, },
|
|
||||||
{ .compatible = "nxp,sc2692", .data = &sc2692, },
|
|
||||||
{ .compatible = "nxp,sc2891", .data = &sc2891, },
|
|
||||||
{ .compatible = "nxp,sc2892", .data = &sc2892, },
|
|
||||||
{ .compatible = "nxp,sc28202", .data = &sc28202, },
|
|
||||||
{ .compatible = "nxp,sc68681", .data = &sc68681, },
|
|
||||||
{ .compatible = "nxp,sc68692", .data = &sc68692, },
|
|
||||||
{ }
|
|
||||||
};
|
|
||||||
MODULE_DEVICE_TABLE(of, sccnxp_dt_id_table);
|
|
||||||
|
|
||||||
static int sccnxp_probe(struct platform_device *pdev)
|
static int sccnxp_probe(struct platform_device *pdev)
|
||||||
{
|
{
|
||||||
struct resource *res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
|
struct resource *res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
|
||||||
struct sccnxp_pdata *pdata = dev_get_platdata(&pdev->dev);
|
struct sccnxp_pdata *pdata = dev_get_platdata(&pdev->dev);
|
||||||
const struct of_device_id *of_id =
|
|
||||||
of_match_device(sccnxp_dt_id_table, &pdev->dev);
|
|
||||||
int i, ret, uartclk;
|
int i, ret, uartclk;
|
||||||
struct sccnxp_port *s;
|
struct sccnxp_port *s;
|
||||||
void __iomem *membase;
|
void __iomem *membase;
|
||||||
|
@ -892,22 +875,7 @@ static int sccnxp_probe(struct platform_device *pdev)
|
||||||
|
|
||||||
spin_lock_init(&s->lock);
|
spin_lock_init(&s->lock);
|
||||||
|
|
||||||
if (of_id) {
|
s->chip = (struct sccnxp_chip *)pdev->id_entry->driver_data;
|
||||||
s->chip = (struct sccnxp_chip *)of_id->data;
|
|
||||||
|
|
||||||
of_property_read_u32(pdev->dev.of_node, "poll-interval",
|
|
||||||
&s->pdata.poll_time_us);
|
|
||||||
of_property_read_u32(pdev->dev.of_node, "reg-shift",
|
|
||||||
&s->pdata.reg_shift);
|
|
||||||
of_property_read_u32_array(pdev->dev.of_node,
|
|
||||||
"nxp,sccnxp-io-cfg",
|
|
||||||
s->pdata.mctrl_cfg, s->chip->nr);
|
|
||||||
} else {
|
|
||||||
s->chip = (struct sccnxp_chip *)pdev->id_entry->driver_data;
|
|
||||||
|
|
||||||
if (pdata)
|
|
||||||
memcpy(&s->pdata, pdata, sizeof(struct sccnxp_pdata));
|
|
||||||
}
|
|
||||||
|
|
||||||
s->regulator = devm_regulator_get(&pdev->dev, "vcc");
|
s->regulator = devm_regulator_get(&pdev->dev, "vcc");
|
||||||
if (!IS_ERR(s->regulator)) {
|
if (!IS_ERR(s->regulator)) {
|
||||||
|
@ -938,11 +906,16 @@ static int sccnxp_probe(struct platform_device *pdev)
|
||||||
goto err_out;
|
goto err_out;
|
||||||
}
|
}
|
||||||
|
|
||||||
|
if (pdata)
|
||||||
|
memcpy(&s->pdata, pdata, sizeof(struct sccnxp_pdata));
|
||||||
|
|
||||||
if (s->pdata.poll_time_us) {
|
if (s->pdata.poll_time_us) {
|
||||||
dev_info(&pdev->dev, "Using poll mode, resolution %u usecs\n",
|
dev_info(&pdev->dev, "Using poll mode, resolution %u usecs\n",
|
||||||
s->pdata.poll_time_us);
|
s->pdata.poll_time_us);
|
||||||
s->poll = 1;
|
s->poll = 1;
|
||||||
} else {
|
}
|
||||||
|
|
||||||
|
if (!s->poll) {
|
||||||
s->irq = platform_get_irq(pdev, 0);
|
s->irq = platform_get_irq(pdev, 0);
|
||||||
if (s->irq < 0) {
|
if (s->irq < 0) {
|
||||||
dev_err(&pdev->dev, "Missing irq resource data\n");
|
dev_err(&pdev->dev, "Missing irq resource data\n");
|
||||||
|
@ -1043,9 +1016,8 @@ static int sccnxp_remove(struct platform_device *pdev)
|
||||||
|
|
||||||
static struct platform_driver sccnxp_uart_driver = {
|
static struct platform_driver sccnxp_uart_driver = {
|
||||||
.driver = {
|
.driver = {
|
||||||
.name = SCCNXP_NAME,
|
.name = SCCNXP_NAME,
|
||||||
.owner = THIS_MODULE,
|
.owner = THIS_MODULE,
|
||||||
.of_match_table = sccnxp_dt_id_table,
|
|
||||||
},
|
},
|
||||||
.probe = sccnxp_probe,
|
.probe = sccnxp_probe,
|
||||||
.remove = sccnxp_remove,
|
.remove = sccnxp_remove,
|
||||||
|
|
|
@ -78,11 +78,11 @@
|
||||||
/* SCCNXP platform data structure */
|
/* SCCNXP platform data structure */
|
||||||
struct sccnxp_pdata {
|
struct sccnxp_pdata {
|
||||||
/* Shift for A0 line */
|
/* Shift for A0 line */
|
||||||
u32 reg_shift;
|
const u8 reg_shift;
|
||||||
/* Modem control lines configuration */
|
/* Modem control lines configuration */
|
||||||
u32 mctrl_cfg[SCCNXP_MAX_UARTS];
|
const u32 mctrl_cfg[SCCNXP_MAX_UARTS];
|
||||||
/* Timer value for polling mode (usecs) */
|
/* Timer value for polling mode (usecs) */
|
||||||
u32 poll_time_us;
|
const unsigned int poll_time_us;
|
||||||
};
|
};
|
||||||
|
|
||||||
#endif
|
#endif
|
||||||
|
|
Loading…
Reference in a new issue