ARM: dts: Ux500: move USB PHY pins to PHY device
The physical pins from the SoC are in a sense belonging to the PHY device (AB8500 USB) rather than the MUSB USB IP block. The driver definately assumes so: before this change it complains that it cannot control the pins it is using: abx5x0-usb ab8500-usb.0: could not get/set default pinstate After this patch the warning goes away. Cc: Ulf Hansson <ulf.hansson@linaro.org> Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This commit is contained in:
parent
adef953bbc
commit
6097c2d0af
|
@ -19,12 +19,6 @@
|
|||
};
|
||||
|
||||
soc {
|
||||
usb_per5@a03e0000 {
|
||||
pinctrl-names = "default", "sleep";
|
||||
pinctrl-0 = <&musb_default_mode>;
|
||||
pinctrl-1 = <&musb_sleep_mode>;
|
||||
};
|
||||
|
||||
uart@80120000 {
|
||||
pinctrl-names = "default", "sleep";
|
||||
pinctrl-0 = <&uart0_default_mode>;
|
||||
|
@ -225,6 +219,12 @@
|
|||
ab8500-gpio {
|
||||
};
|
||||
|
||||
ab8500_usb {
|
||||
pinctrl-names = "default", "sleep";
|
||||
pinctrl-0 = <&musb_default_mode>;
|
||||
pinctrl-1 = <&musb_sleep_mode>;
|
||||
};
|
||||
|
||||
ab8500-regulators {
|
||||
ab8500_ldo_aux1_reg: ab8500_ldo_aux1 {
|
||||
regulator-name = "V-DISPLAY";
|
||||
|
|
|
@ -159,12 +159,6 @@
|
|||
"", "", "", "", "", "", "", "";
|
||||
};
|
||||
|
||||
usb_per5@a03e0000 {
|
||||
pinctrl-names = "default", "sleep";
|
||||
pinctrl-0 = <&musb_default_mode>;
|
||||
pinctrl-1 = <&musb_sleep_mode>;
|
||||
};
|
||||
|
||||
sound {
|
||||
compatible = "stericsson,snd-soc-mop500";
|
||||
|
||||
|
@ -451,6 +445,12 @@
|
|||
"PM_GPIO42"; /* AB8500 GPIO42 */
|
||||
};
|
||||
|
||||
ab8500_usb {
|
||||
pinctrl-names = "default", "sleep";
|
||||
pinctrl-0 = <&musb_default_mode>;
|
||||
pinctrl-1 = <&musb_sleep_mode>;
|
||||
};
|
||||
|
||||
ext_regulators: ab8500-ext-regulators {
|
||||
ab8500_ext1_reg: ab8500_ext1 {
|
||||
regulator-name = "ab8500-ext-supply1";
|
||||
|
|
Loading…
Reference in a new issue