spi: rspi: Increase accuracy of bit rate for RZ
When you leave the clock divider at 0, 130kHz is the lowest you can go. Also, by adjusting the clock divider you can get more accurate resolutions for clock speeds lower than 16MHz. This patch uses the clock divider as part of the bit rate setup. Signed-off-by: Chris Brandt <chris.brandt@renesas.com> Signed-off-by: Mark Brown <broonie@kernel.org>
This commit is contained in:
parent
29b4817d40
commit
aeb8f8cb15
|
@ -295,14 +295,24 @@ static int rspi_set_config_register(struct rspi_data *rspi, int access_size)
|
|||
static int rspi_rz_set_config_register(struct rspi_data *rspi, int access_size)
|
||||
{
|
||||
int spbr;
|
||||
int div = 0;
|
||||
unsigned long clksrc;
|
||||
|
||||
/* Sets output mode, MOSI signal, and (optionally) loopback */
|
||||
rspi_write8(rspi, rspi->sppcr, RSPI_SPPCR);
|
||||
|
||||
clksrc = clk_get_rate(rspi->clk);
|
||||
while (div < 3) {
|
||||
if (rspi->max_speed_hz >= clksrc/4) /* 4=(CLK/2)/2 */
|
||||
break;
|
||||
div++;
|
||||
clksrc /= 2;
|
||||
}
|
||||
|
||||
/* Sets transfer bit rate */
|
||||
spbr = DIV_ROUND_UP(clk_get_rate(rspi->clk),
|
||||
2 * rspi->max_speed_hz) - 1;
|
||||
spbr = DIV_ROUND_UP(clksrc, 2 * rspi->max_speed_hz) - 1;
|
||||
rspi_write8(rspi, clamp(spbr, 0, 255), RSPI_SPBR);
|
||||
rspi->spcmd |= div << 2;
|
||||
|
||||
/* Disable dummy transmission, set byte access */
|
||||
rspi_write8(rspi, SPDCR_SPLBYTE, RSPI_SPDCR);
|
||||
|
|
Loading…
Reference in a new issue