clk: tegra: Fix pll_u rate configuration
Turns out latest upstream U-Boot does not configure/enable pll_u which leaves it at some default rate of 500 kHz: root@apalis-t30:~# cat /sys/kernel/debug/clk/clk_summary | grep pll_u pll_u 3 3 0 500000 0 Of course this won't quite work leading to the following messages: [ 6.559593] usb 2-1: new full-speed USB device number 2 using tegra- ehci [ 11.759173] usb 2-1: device descriptor read/64, error -110 [ 27.119453] usb 2-1: device descriptor read/64, error -110 [ 27.389217] usb 2-1: new full-speed USB device number 3 using tegra- ehci [ 32.559454] usb 2-1: device descriptor read/64, error -110 [ 47.929777] usb 2-1: device descriptor read/64, error -110 [ 48.049658] usb usb2-port1: attempt power cycle [ 48.759475] usb 2-1: new full-speed USB device number 4 using tegra- ehci [ 59.349457] usb 2-1: device not accepting address 4, error -110 [ 59.509449] usb 2-1: new full-speed USB device number 5 using tegra- ehci [ 70.069457] usb 2-1: device not accepting address 5, error -110 [ 70.079721] usb usb2-port1: unable to enumerate USB device Fix this by actually allowing the rate also being set from within the Linux kernel. Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com> Tested-by: Jon Hunter <jonathanh@nvidia.com> Signed-off-by: Thierry Reding <treding@nvidia.com>
This commit is contained in:
parent
c485ad63ab
commit
c35b518f9b
|
@ -1151,6 +1151,8 @@ static const struct clk_ops tegra_clk_pllu_ops = {
|
|||
.enable = clk_pllu_enable,
|
||||
.disable = clk_pll_disable,
|
||||
.recalc_rate = clk_pll_recalc_rate,
|
||||
.round_rate = clk_pll_round_rate,
|
||||
.set_rate = clk_pll_set_rate,
|
||||
};
|
||||
|
||||
static int _pll_fixed_mdiv(struct tegra_clk_pll_params *pll_params,
|
||||
|
|
Loading…
Reference in a new issue