dcfb81d61d
OMAP-L137/AM17x has limited number of dedicated EMIFA address pins, enough to interface directly to an SDRAM. If a device such as an asynchronous flash needs to be attached to the EMIFA, then either GPIO pins or a chip select may be used to control the flash device's upper address lines. This patch adds support for the NOR flash on the OMAP-L137/ AM17x user interface daughter board using the latch-addr-flash MTD mapping driver which allows flashes to be partially physically addressed. The upper address lines are set by a board specific code which is a separate patch. Signed-off-by: David Griego <dgriego@mvista.com> Signed-off-by: Aleksey Makarov <amakarov@ru.mvista.com> Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com> Signed-off-by: Savinay Dharmappa <savinay.dharmappa@ti.com> Signed-off-by: Artem Bityutskiy <Artem.Bityutskiy@nokia.com> Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
63 lines
2.3 KiB
Makefile
63 lines
2.3 KiB
Makefile
#
|
|
# linux/drivers/maps/Makefile
|
|
#
|
|
|
|
ifeq ($(CONFIG_MTD_COMPLEX_MAPPINGS),y)
|
|
obj-$(CONFIG_MTD) += map_funcs.o
|
|
endif
|
|
|
|
# Chip mappings
|
|
obj-$(CONFIG_MTD_CDB89712) += cdb89712.o
|
|
obj-$(CONFIG_MTD_ARM_INTEGRATOR)+= integrator-flash.o
|
|
obj-$(CONFIG_MTD_CFI_FLAGADM) += cfi_flagadm.o
|
|
obj-$(CONFIG_MTD_DC21285) += dc21285.o
|
|
obj-$(CONFIG_MTD_DILNETPC) += dilnetpc.o
|
|
obj-$(CONFIG_MTD_L440GX) += l440gx.o
|
|
obj-$(CONFIG_MTD_AMD76XROM) += amd76xrom.o
|
|
obj-$(CONFIG_MTD_ESB2ROM) += esb2rom.o
|
|
obj-$(CONFIG_MTD_ICHXROM) += ichxrom.o
|
|
obj-$(CONFIG_MTD_CK804XROM) += ck804xrom.o
|
|
obj-$(CONFIG_MTD_TSUNAMI) += tsunami_flash.o
|
|
obj-$(CONFIG_MTD_PXA2XX) += pxa2xx-flash.o
|
|
obj-$(CONFIG_MTD_MBX860) += mbx860.o
|
|
obj-$(CONFIG_MTD_CEIVA) += ceiva.o
|
|
obj-$(CONFIG_MTD_OCTAGON) += octagon-5066.o
|
|
obj-$(CONFIG_MTD_PHYSMAP) += physmap.o
|
|
obj-$(CONFIG_MTD_PHYSMAP_OF) += physmap_of.o
|
|
obj-$(CONFIG_MTD_PISMO) += pismo.o
|
|
obj-$(CONFIG_MTD_PMC_MSP_EVM) += pmcmsp-flash.o
|
|
obj-$(CONFIG_MTD_PCMCIA) += pcmciamtd.o
|
|
obj-$(CONFIG_MTD_RPXLITE) += rpxlite.o
|
|
obj-$(CONFIG_MTD_TQM8XXL) += tqm8xxl.o
|
|
obj-$(CONFIG_MTD_SA1100) += sa1100-flash.o
|
|
obj-$(CONFIG_MTD_SBC_GXX) += sbc_gxx.o
|
|
obj-$(CONFIG_MTD_SC520CDP) += sc520cdp.o
|
|
obj-$(CONFIG_MTD_NETSC520) += netsc520.o
|
|
obj-$(CONFIG_MTD_TS5500) += ts5500_flash.o
|
|
obj-$(CONFIG_MTD_SUN_UFLASH) += sun_uflash.o
|
|
obj-$(CONFIG_MTD_VMAX) += vmax301.o
|
|
obj-$(CONFIG_MTD_SCx200_DOCFLASH)+= scx200_docflash.o
|
|
obj-$(CONFIG_MTD_DBOX2) += dbox2-flash.o
|
|
obj-$(CONFIG_MTD_SOLUTIONENGINE)+= solutionengine.o
|
|
obj-$(CONFIG_MTD_PCI) += pci.o
|
|
obj-$(CONFIG_MTD_AUTCPU12) += autcpu12-nvram.o
|
|
obj-$(CONFIG_MTD_EDB7312) += edb7312.o
|
|
obj-$(CONFIG_MTD_IMPA7) += impa7.o
|
|
obj-$(CONFIG_MTD_FORTUNET) += fortunet.o
|
|
obj-$(CONFIG_MTD_UCLINUX) += uclinux.o
|
|
obj-$(CONFIG_MTD_NETtel) += nettel.o
|
|
obj-$(CONFIG_MTD_SCB2_FLASH) += scb2_flash.o
|
|
obj-$(CONFIG_MTD_H720X) += h720x-flash.o
|
|
obj-$(CONFIG_MTD_IXP4XX) += ixp4xx.o
|
|
obj-$(CONFIG_MTD_IXP2000) += ixp2000.o
|
|
obj-$(CONFIG_MTD_WRSBC8260) += wr_sbc82xx_flash.o
|
|
obj-$(CONFIG_MTD_DMV182) += dmv182.o
|
|
obj-$(CONFIG_MTD_PLATRAM) += plat-ram.o
|
|
obj-$(CONFIG_MTD_INTEL_VR_NOR) += intel_vr_nor.o
|
|
obj-$(CONFIG_MTD_BFIN_ASYNC) += bfin-async-flash.o
|
|
obj-$(CONFIG_MTD_RBTX4939) += rbtx4939-flash.o
|
|
obj-$(CONFIG_MTD_VMU) += vmu-flash.o
|
|
obj-$(CONFIG_MTD_GPIO_ADDR) += gpio-addr-flash.o
|
|
obj-$(CONFIG_MTD_BCM963XX) += bcm963xx-flash.o
|
|
obj-$(CONFIG_MTD_LATCH_ADDR) += latch-addr-flash.o
|