fsl_esdhc: Fix multi-block read restriction on i.MX53 eSDHCv2

For freescale i.MX53 eSDHCv2, when using CMD12, cmdtype need
to be set to ABORT, otherwise, next read command will hang.

This is a software Software Restrictions in i.MX53 reference manual:

29.7.8 Multi-block Read
For pre-defined multi-block read operation, that is,the number of blocks
to read has been defined by previous CMD23 for MMC, or pre-defined number
of blocks in CMD53 for SDIO/SDCombo,or whatever multi-block read without
abort command at card side, an abort command, either automatic or manual
CMD12/CMD52, is still required by ESDHC after the pre-defined number of
blocks are done, to drive the internal state machine to idle mode. In this
case, the card may not respond to this extra abort command and ESDHC will
get Response Timeout.  It is recommended to manually send an abort command
with RSPTYP[1:0] both bits cleared.

Signed-off-by: Jason Liu <jason.hui@linaro.org>
This commit is contained in:
Jason Liu 2011-03-22 01:32:31 +00:00 committed by Andy Fleming
parent 4ca9244d74
commit 4571de33ee

View file

@ -99,6 +99,10 @@ uint esdhc_xfertyp(struct mmc_cmd *cmd, struct mmc_data *data)
else if (cmd->resp_type & MMC_RSP_PRESENT)
xfertyp |= XFERTYP_RSPTYP_48;
#ifdef CONFIG_MX53
if (cmd->cmdidx == MMC_CMD_STOP_TRANSMISSION)
xfertyp |= XFERTYP_CMDTYP_ABORT;
#endif
return XFERTYP_CMD(cmd->cmdidx) | xfertyp;
}