tsec: Wait for auto-negotiation to complete without link

Previously, waiting for auto-negotiation would only occur if a valid
link had been detected.  Problems arose when attempting to use a
tsec immediately after bootup but before link was achieved, eg:
=> dhcp
Auto-neg error, defaulting to 10BT/HD
eTSEC1: No link.
Auto-neg error, defaulting to 10BT/HD
eTSEC2: No link.
=>

With this patch applied the same operation as above resulted in:
=> dhcp
Waiting for PHY auto negotiation to complete. done
Enet starting in 1000BT/FD
Speed: 1000, full duplex

Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
Signed-off-by: Ben Warren <biggerbadderben@gmail.com>
This commit is contained in:
Peter Tyser 2009-02-04 15:14:05 -06:00 committed by Ben Warren
parent 477fa6378f
commit b1e849f220

View file

@ -356,8 +356,8 @@ uint mii_cr_init(uint mii_reg, struct tsec_private * priv)
return MIIM_CR_INIT;
}
/* Parse the status register for link, and then do
* auto-negotiation
/*
* Wait for auto-negotiation to complete, then determine link
*/
uint mii_parse_sr(uint mii_reg, struct tsec_private * priv)
{
@ -366,8 +366,7 @@ uint mii_parse_sr(uint mii_reg, struct tsec_private * priv)
* (ie - we're capable and it's not done)
*/
mii_reg = read_phy_reg(priv, MIIM_STATUS);
if ((mii_reg & MIIM_STATUS_LINK) && (mii_reg & PHY_BMSR_AUTN_ABLE)
&& !(mii_reg & PHY_BMSR_AUTN_COMP)) {
if ((mii_reg & PHY_BMSR_AUTN_ABLE) && !(mii_reg & PHY_BMSR_AUTN_COMP)) {
int i = 0;
puts("Waiting for PHY auto negotiation to complete");
@ -388,15 +387,15 @@ uint mii_parse_sr(uint mii_reg, struct tsec_private * priv)
mii_reg = read_phy_reg(priv, MIIM_STATUS);
}
puts(" done\n");
priv->link = 1;
/* Link status bit is latched low, read it again */
mii_reg = read_phy_reg(priv, MIIM_STATUS);
udelay(500000); /* another 500 ms (results in faster booting) */
} else {
if (mii_reg & MIIM_STATUS_LINK)
priv->link = 1;
else
priv->link = 0;
}
priv->link = mii_reg & MIIM_STATUS_LINK ? 1 : 0;
return 0;
}