panda/board/pedal
Kevin Roscom 4522320fdc use SAE J1850 for pedal 2022-02-23 00:12:44 -06:00
..
.gitignore Pedal: only one firmware (#164) 2019-03-03 21:04:41 -08:00
README Pedal: only one firmware (#164) 2019-03-03 21:04:41 -08:00
flash_can.sh Switch panda to scons builder (#635) 2021-03-24 14:44:32 +01:00
main.c use SAE J1850 for pedal 2022-02-23 00:12:44 -06:00
main_declarations.h Black (#254) 2019-07-23 15:07:06 -07:00
recover.sh Switch panda to scons builder (#635) 2021-03-24 14:44:32 +01:00

README

This is the firmware for the comma pedal. It borrows a lot from panda.

The comma pedal is a gas pedal interceptor for Honda/Acura. It allows you to "virtually" press the pedal.

This is the open source software. Note that it is not ready to use yet.

== Test Plan ==

* Startup
** Confirm STATE_FAULT_STARTUP
* Timeout
** Send value
** Confirm value is output
** Stop sending messages
** Confirm value is passthru after 100ms
** Confirm STATE_FAULT_TIMEOUT
* Random values
** Send random 6 byte messages
** Confirm random values cause passthru
** Confirm STATE_FAULT_BAD_CHECKSUM
* Same message lockout
** Send same message repeated
** Confirm timeout behavior
* Don't set enable
** Confirm no output
* Set enable and values
** Confirm output