Currently it is difficult to deploy uPy on form factor devices without
a reset pin. Any mistake in the boot code risks the system getting
stuck (at least until the battery goes flat). A watchdog and user
button can be combined to give a long-press reset that gives the user
a better shot at recovering the device before the battery runs down!
Move webrepl support code from ports/esp8266/modules into extmod/webrepl
(to be alongside extmod/modwebrepl.c), and use frozen manifests to include
it in the build on esp8266 and esp32.
A small modification is made to webrepl.py to make it work on non-ESP
ports, i.e. don't call dupterm_notify if not available.
This is an alternative to f4ed2df that adds a newline so that the output of
the test starts on a new line and the result of the test is prefixed with
"result: " to distinguish it from the test output.
Suggested-by: @dpgeorge
This reverts commit f4ed2dfa94.
This lets tinytest work as it was originally designed. An alternate
solution for the reverted commit will be implemented in a future commit.
This patch allows executing .mpy files (including native ones) directly on
a target, eg a board over a serial connection. So there's no need to copy
the file to its filesystem to test it.
For example:
$ mpy-cross foo.py
$ pyboard.py foo.mpy
- Corrected pin assignments and checked with CubeMX.
- Added additional I2C and UARTs.
- Added Ethernet interface definitions with lwIP and SSL support (but
Ethernet is currently unsupported on H7 MCUs so not fully enabled).
- Removed remarks on DFU/OCD in mpconfigboard.h because deploy-stlink works
fine too.
- Added more UARTs, I2C, corrected SPI, CAN, etc; verified against CubeMX.
- Adapted pins.csv to remove errors, add omissions, etc. according to
NUCLEO-144 User Manual.
- Changed linker file stm32f767.ld to reflect correct size of the Flash.
- Tested with LAN and SD card.
The Nucleo board does not have an SD card slot but does have the requisite
pins next to each other and labelled, so provide the configuration for
convenience.
This makes the loading of viper-code-with-relocations a bit neater and
easier to understand, by treating the rodata/bss like a special object to
be loaded into the constant table (which is how it behaves).
Because CPython 3.8.0 now produces different output:
- basics/parser.py: CPython does not allow '\\\n' as input.
- import/import_override: CPython imports _io.
Daniel Thompson