alistair23-linux/arch/arm/mach-imx
Lucas Stach d438462c20 ARM: imx6: gpc: always enable PU domain if CONFIG_PM is not set
If CONFIG_PM is not set the PU power domain needs to be enabled always,
otherwise there are two failure scenarios which will hang the system if
one of the devices in the PU domain is accessed.

1. New DTs (4.1+) drop the "always-on" property from the PU regulator, so
if it isn't properly enabled by the GPC code it will be disabled at the
end of boot.

2. If the bootloader already disabled the PU domain the GPC explicitly
needs to enable it again, even if the kernel doesn't do any power
management. This is a bit hypothetical, as it requires to boot a
mainline kernel on a downstream bootloader, as no mainline bootloader
disables the PM domains.

Cc: <stable@vger.kernel.org> # 4.1
Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
Acked-by: Philipp Zabel <p.zabel@pengutronix.de>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
2015-07-08 22:52:08 +08:00
..
devices ARM: mach-imx: devices: platform-sdhci-esdhc-imx: fix broken email address 2015-04-27 20:37:06 +08:00
3ds_debugboard.c
3ds_debugboard.h
anatop.c ARM: imx: add msl support for imx7d 2015-06-03 14:49:35 +08:00
avic.c
board-mx31lilly.h
board-mx31lite.h
board-mx31moboard.h
common.h ARM: imx53: Set DDR pins to high impedance when in suspend to RAM. 2015-06-03 14:49:36 +08:00
cpu-imx5.c
cpu-imx25.c ARM: mx25: Retrieve IIM base from dt 2015-03-13 22:06:35 +08:00
cpu-imx27.c
cpu-imx31.c
cpu-imx35.c
cpu.c ARM: imx: add msl support for imx7d 2015-06-03 14:49:35 +08:00
cpuidle-imx5.c cpuidle: Invert CPUIDLE_FLAG_TIME_VALID logic 2014-11-12 21:17:27 +01:00
cpuidle-imx6q.c ARM: imx6: set initial power mode in pm function 2015-06-03 14:44:31 +08:00
cpuidle-imx6sl.c ARM: imx6: set initial power mode in pm function 2015-06-03 14:44:31 +08:00
cpuidle-imx6sx.c ARM: imx6: set initial power mode in pm function 2015-06-03 14:44:31 +08:00
cpuidle.h ARM: imx: support arm power off in cpuidle for i.mx6sx 2015-01-05 21:34:29 +08:00
crmregs-imx3.h
devices-imx1.h
devices-imx21.h
devices-imx27.h
devices-imx31.h
devices-imx35.h
ehci-imx27.c
ehci-imx31.c
ehci-imx35.c
ehci.h
epit.c
eukrea-baseboards.h
gpc.c ARM: imx6: gpc: always enable PU domain if CONFIG_PM is not set 2015-07-08 22:52:08 +08:00
hardware.h ARM: imx: move revision definitions and declarations into a header 2015-06-03 14:44:30 +08:00
headsmp.S ARM: v7 setup function should invalidate L1 cache 2015-06-01 11:30:26 +01:00
hotplug.c
iim.h
imx1-dt.c ARM: i.MX1: Add devicetree support 2014-09-16 10:06:44 +08:00
imx27-dt.c ARM: imx: clean up machine mxc_arch_reset_init_dt reset init 2014-11-22 07:39:36 +08:00
imx31-dt.c ARM: imx: clean up machine mxc_arch_reset_init_dt reset init 2014-11-22 07:39:36 +08:00
imx35-dt.c ARM: imx: clean up machine mxc_arch_reset_init_dt reset init 2014-11-22 07:39:36 +08:00
iomux-imx31.c ARM: mach-imx: iomux-imx31: Use DECLARE_BITMAP 2015-06-03 14:49:38 +08:00
iomux-mx1.h
iomux-mx2x.h
iomux-mx3.h ARM: imx: Fix trivial typo in comments 2015-03-03 12:05:46 +08:00
iomux-mx21.h
iomux-mx27.h
iomux-mx35.h
iomux-v1.c
iomux-v1.h
iomux-v3.c ARM: imx/iomux-v3: allow pad_list to be const 2015-03-03 12:04:41 +08:00
iomux-v3.h ARM: imx: Fix trivial typo in comments 2015-03-03 12:05:46 +08:00
irq-common.c
irq-common.h
Kconfig ARM: SoC: platform support for v4.2 2015-06-26 11:34:35 -07:00
mach-apf9328.c
mach-armadillo5x0.c arm: mach-imx: Convert pr_warning to pr_warn 2014-09-16 10:09:41 +08:00
mach-bug.c
mach-imx6q.c ARM: imx6: initialize CCM_CLPCR_LPM into RUN mode earlier 2015-06-03 14:49:18 +08:00
mach-imx6sl.c ARM: imx6: initialize CCM_CLPCR_LPM into RUN mode earlier 2015-06-03 14:49:18 +08:00
mach-imx6sx.c ARM: imx6: initialize CCM_CLPCR_LPM into RUN mode earlier 2015-06-03 14:49:18 +08:00
mach-imx7d.c ARM: imx: add msl support for imx7d 2015-06-03 14:49:35 +08:00
mach-imx25.c ARM: mx25: Remove static memory mapping 2015-03-13 22:14:57 +08:00
mach-imx27_visstrim_m10.c
mach-imx50.c ARM: imx: clean up machine mxc_arch_reset_init_dt reset init 2014-11-22 07:39:36 +08:00
mach-imx51.c ARM: imx: clean up machine mxc_arch_reset_init_dt reset init 2014-11-22 07:39:36 +08:00
mach-imx53.c ARM: SoC platform changes for 3.19 2014-12-09 14:38:28 -08:00
mach-kzm_arm11_01.c
mach-ls1021a.c ARM: imx: Add Freescale LS1021A SMP support 2014-11-23 14:56:21 +08:00
mach-mx21ads.c
mach-mx27_3ds.c
mach-mx27ads.c
mach-mx31_3ds.c arm: mach-imx: Convert pr_warning to pr_warn 2014-09-16 10:09:41 +08:00
mach-mx31ads.c
mach-mx31lilly.c
mach-mx31lite.c arm: mach-imx: Convert pr_warning to pr_warn 2014-09-16 10:09:41 +08:00
mach-mx31moboard.c
mach-mx35_3ds.c ARM: imx/iomux-v3: allow pad_list to be const 2015-03-03 12:04:41 +08:00
mach-pca100.c
mach-pcm037.c arm: mach-imx: Convert pr_warning to pr_warn 2014-09-16 10:09:41 +08:00
mach-pcm037_eet.c
mach-pcm043.c ARM: imx/iomux-v3: allow pad_list to be const 2015-03-03 12:04:41 +08:00
mach-qong.c
mach-scb9328.c
mach-vf610.c ARM: vf610: enable Cortex-M4 configuration on Vybrid SoC 2015-05-20 23:10:14 +02:00
mach-vpr200.c ARM: imx/iomux-v3: allow pad_list to be const 2015-03-03 12:04:41 +08:00
Makefile ARM: SoC: platform support for v4.2 2015-06-26 11:34:35 -07:00
Makefile.boot ARM: vf610: enable Cortex-M4 configuration on Vybrid SoC 2015-05-20 23:10:14 +02:00
mm-imx1.c
mm-imx3.c
mm-imx21.c
mm-imx27.c
mmdc.c ARM: imx: mmdc: Include "common.h" header file 2015-06-03 14:49:34 +08:00
mx1.h
mx2x.h
mx3x.h ARM: imx: move revision definitions and declarations into a header 2015-06-03 14:44:30 +08:00
mx21.h
mx27.h ARM: imx: move revision definitions and declarations into a header 2015-06-03 14:44:30 +08:00
mx31.h
mx31lilly-db.c
mx31lite-db.c
mx31moboard-devboard.c
mx31moboard-marxbot.c
mx31moboard-smartbot.c
mx35.h
mxc.h ARM: imx: add msl support for imx7d 2015-06-03 14:49:35 +08:00
pcm037.h
platsmp.c ARM: imx: Add Freescale LS1021A SMP support 2014-11-23 14:56:21 +08:00
pm-imx3.c
pm-imx5.c genalloc: rename dev_get_gen_pool() to gen_pool_get() 2015-06-30 19:45:01 -07:00
pm-imx6.c genalloc: rename dev_get_gen_pool() to gen_pool_get() 2015-06-30 19:45:01 -07:00
pm-imx27.c
src.c
ssi-fiq-ksym.c
ssi-fiq.S
suspend-imx6.S ARM: imx: replace cpu type check with ddr type check 2014-11-23 14:56:17 +08:00
suspend-imx53.S ARM: imx53: Set DDR pins to high impedance when in suspend to RAM. 2015-06-03 14:49:36 +08:00
system.c ARM: imx: clean up machine mxc_arch_reset_init_dt reset init 2014-11-22 07:39:36 +08:00
tzic.c
ulpi.h