remove the notes for now as this leads to confusion
parent
6be374d3bf
commit
549aced2e8
|
@ -22,7 +22,7 @@ To put the rM2 in recovery, you will need:
|
|||
* run `dmesg -w` on your host to monitor
|
||||
* power off the device
|
||||
* connect the USB-C breakout board
|
||||
* pull down **B8** (connect a 10K resistor to GND)
|
||||
* pull down **B8** (connect B8 over a 10K resistor to B1)
|
||||
* connect the pogo pins to the tablet and to the host usb
|
||||
* **make sure the connection is good, use a short good, different cable, etc**
|
||||
* if the device does not start on its own, press the Power Button
|
||||
|
@ -32,7 +32,3 @@ To put the rM2 in recovery, you will need:
|
|||
* should see *USB Mass Storage device detected*
|
||||
* should see a new mountable block device
|
||||
|
||||
## Notes
|
||||
|
||||
- B8 has to be connected to the same ground as the Pogo GND pin
|
||||
- The ID pin on Pogo connector is not connected to anything
|
||||
|
|
Loading…
Reference in New Issue